Subject: [RESEND v1 0/2] Close UART port if NON_PERSISTENT_SETUP is set

When HCI_QUIRK_NON_PERSISTENT_SETUP is set by drivers,
it indicates that BT SoC will be completely powered OFF
during BT OFF. On next BT ON firmware must be downloaded
again. Holding UART port open during BT OFF is draining
the battery. Now during BT OFF, UART port is closed if
qurik HCI_QUIRK_NON_PERSISTENT_SETUP is set by clearing
HCI_UART_PROTO_READY proto flag. On next BT ON, UART
port is opened if HCI_UART_PROTO_READY proto flag is cleared.

Venkata Lakshmi Narayana Gubba (2):
Bluetooth: hci_serdev: Close UART port if NON_PERSISTENT_SETUP is set
Bluetooth: hci_qca: Remove duplicate power off in proto close

drivers/bluetooth/hci_qca.c | 5 ++---
drivers/bluetooth/hci_serdev.c | 36 +++++++++++++++++++++++++++++++++---
2 files changed, 35 insertions(+), 6 deletions(-)

--
QUALCOMM INDIA, on behalf of Qualcomm Innovation Center, Inc. is a member
of Code Aurora Forum, hosted by The Linux Foundation


2020-09-11 07:11:14

by Marcel Holtmann

[permalink] [raw]
Subject: Re: [RESEND v1 0/2] Close UART port if NON_PERSISTENT_SETUP is set

Hi Venkata,

> When HCI_QUIRK_NON_PERSISTENT_SETUP is set by drivers,
> it indicates that BT SoC will be completely powered OFF
> during BT OFF. On next BT ON firmware must be downloaded
> again. Holding UART port open during BT OFF is draining
> the battery. Now during BT OFF, UART port is closed if
> qurik HCI_QUIRK_NON_PERSISTENT_SETUP is set by clearing
> HCI_UART_PROTO_READY proto flag. On next BT ON, UART
> port is opened if HCI_UART_PROTO_READY proto flag is cleared.
>
> Venkata Lakshmi Narayana Gubba (2):
> Bluetooth: hci_serdev: Close UART port if NON_PERSISTENT_SETUP is set
> Bluetooth: hci_qca: Remove duplicate power off in proto close
>
> drivers/bluetooth/hci_qca.c | 5 ++---
> drivers/bluetooth/hci_serdev.c | 36 +++++++++++++++++++++++++++++++++---
> 2 files changed, 35 insertions(+), 6 deletions(-)

both patches have been applied to bluetooth-next tree.

Regards

Marcel