From: Johan Hedberg <[email protected]>
This driver was recently updated to use serdev, so add the appropriate
dependency. Without this one can get compiler warnings like this if
CONFIG_SERIAL_DEV_BUS is not enabled:
CC [M] drivers/bluetooth/hci_h5.o
drivers/bluetooth/hci_h5.c:934:36: warning: ‘h5_serdev_driver’ defined but not used [-Wunused-variable]
static struct serdev_device_driver h5_serdev_driver = {
^~~~~~~~~~~~~~~~
Signed-off-by: Johan Hedberg <[email protected]>
---
drivers/bluetooth/Kconfig | 1 +
1 file changed, 1 insertion(+)
diff --git a/drivers/bluetooth/Kconfig b/drivers/bluetooth/Kconfig
index f3c643a0473c..5f953ca8ac5b 100644
--- a/drivers/bluetooth/Kconfig
+++ b/drivers/bluetooth/Kconfig
@@ -159,6 +159,7 @@ config BT_HCIUART_LL
config BT_HCIUART_3WIRE
bool "Three-wire UART (H5) protocol support"
depends on BT_HCIUART
+ depends on BT_HCIUART_SERDEV
help
The HCI Three-wire UART Transport Layer makes it possible to
user the Bluetooth HCI over a serial port interface. The HCI
--
2.17.1
Hi Johan,
> This driver was recently updated to use serdev, so add the appropriate
> dependency. Without this one can get compiler warnings like this if
> CONFIG_SERIAL_DEV_BUS is not enabled:
>
> CC [M] drivers/bluetooth/hci_h5.o
> drivers/bluetooth/hci_h5.c:934:36: warning: ‘h5_serdev_driver’ defined but not used [-Wunused-variable]
> static struct serdev_device_driver h5_serdev_driver = {
> ^~~~~~~~~~~~~~~~
>
> Signed-off-by: Johan Hedberg <[email protected]>
> ---
> drivers/bluetooth/Kconfig | 1 +
> 1 file changed, 1 insertion(+)
patch has been applied to bluetooth-next tree.
Regards
Marcel