From: Max Chou <[email protected]>
Add the support for RTL8922A BT controller on USB interface.
The necessary firmware will be submitted to linux-firmware project.
The device info from /sys/kernel/debug/usb/devices as below.
T: Bus=01 Lev=02 Prnt=02 Port=02 Cnt=01 Dev#= 3 Spd=12 MxCh= 0
D: Ver= 1.00 Cls=e0(wlcon) Sub=01 Prot=01 MxPS=64 #Cfgs= 1
P: Vendor=0bda ProdID=8922 Rev= 0.00
S: Manufacturer=Realtek
S: Product=Bluetooth Radio
S: SerialNumber=00E04C885A01
C:* #Ifs= 2 Cfg#= 1 Atr=e0 MxPwr=500mA
I:* If#= 0 Alt= 0 #EPs= 3 Cls=e0(wlcon) Sub=01 Prot=01 Driver=btusb
E: Ad=81(I) Atr=03(Int.) MxPS= 16 Ivl=1ms
E: Ad=02(O) Atr=02(Bulk) MxPS= 64 Ivl=0ms
E: Ad=82(I) Atr=02(Bulk) MxPS= 64 Ivl=0ms
I:* If#= 1 Alt= 0 #EPs= 2 Cls=e0(wlcon) Sub=01 Prot=01 Driver=btusb
E: Ad=03(O) Atr=01(Isoc) MxPS= 0 Ivl=1ms
E: Ad=83(I) Atr=01(Isoc) MxPS= 0 Ivl=1ms
I: If#= 1 Alt= 1 #EPs= 2 Cls=e0(wlcon) Sub=01 Prot=01 Driver=btusb
E: Ad=03(O) Atr=01(Isoc) MxPS= 9 Ivl=1ms
E: Ad=83(I) Atr=01(Isoc) MxPS= 9 Ivl=1ms
I: If#= 1 Alt= 2 #EPs= 2 Cls=e0(wlcon) Sub=01 Prot=01 Driver=btusb
E: Ad=03(O) Atr=01(Isoc) MxPS= 17 Ivl=1ms
E: Ad=83(I) Atr=01(Isoc) MxPS= 17 Ivl=1ms
I: If#= 1 Alt= 3 #EPs= 2 Cls=e0(wlcon) Sub=01 Prot=01 Driver=btusb
E: Ad=03(O) Atr=01(Isoc) MxPS= 25 Ivl=1ms
E: Ad=83(I) Atr=01(Isoc) MxPS= 25 Ivl=1ms
I: If#= 1 Alt= 4 #EPs= 2 Cls=e0(wlcon) Sub=01 Prot=01 Driver=btusb
E: Ad=03(O) Atr=01(Isoc) MxPS= 33 Ivl=1ms
E: Ad=83(I) Atr=01(Isoc) MxPS= 33 Ivl=1ms
I: If#= 1 Alt= 5 #EPs= 2 Cls=e0(wlcon) Sub=01 Prot=01 Driver=btusb
E: Ad=03(O) Atr=01(Isoc) MxPS= 49 Ivl=1ms
E: Ad=83(I) Atr=01(Isoc) MxPS= 49 Ivl=1ms
I: If#= 1 Alt= 6 #EPs= 2 Cls=e0(wlcon) Sub=01 Prot=01 Driver=btusb
E: Ad=03(O) Atr=01(Isoc) MxPS= 63 Ivl=1ms
E: Ad=83(I) Atr=01(Isoc) MxPS= 63 Ivl=1ms
Signed-off-by: Max Chou <[email protected]>
---
change in v2:
- update device info for Driver field.
---
drivers/bluetooth/btrtl.c | 16 ++++++++++++++++
drivers/bluetooth/btusb.c | 11 +++++++++++
2 files changed, 27 insertions(+)
diff --git a/drivers/bluetooth/btrtl.c b/drivers/bluetooth/btrtl.c
index cc50de69e8dc..51a2d459cf6d 100644
--- a/drivers/bluetooth/btrtl.c
+++ b/drivers/bluetooth/btrtl.c
@@ -30,6 +30,7 @@
#define RTL_ROM_LMP_8822B 0x8822
#define RTL_ROM_LMP_8852A 0x8852
#define RTL_ROM_LMP_8851B 0x8851
+#define RTL_ROM_LMP_8922A 0x8922
#define RTL_CONFIG_MAGIC 0x8723ab55
#define RTL_VSC_OP_COREDUMP 0xfcff
@@ -69,6 +70,7 @@ enum btrtl_chip_id {
CHIP_ID_8852B = 20,
CHIP_ID_8852C = 25,
CHIP_ID_8851B = 36,
+ CHIP_ID_8922A = 44,
CHIP_ID_8852BT = 47,
};
@@ -309,6 +311,15 @@ static const struct id_table ic_id_table[] = {
.cfg_name = "rtl_bt/rtl8851bu_config",
.hw_info = "rtl8851bu" },
+ /* 8922A */
+ { IC_INFO(RTL_ROM_LMP_8922A, 0xa, 0xc, HCI_USB),
+ .config_needed = false,
+ .has_rom_version = true,
+ .has_msft_ext = true,
+ .fw_name = "rtl_bt/rtl8922au_fw",
+ .cfg_name = "rtl_bt/rtl8922au_config",
+ .hw_info = "rtl8922au" },
+
/* 8852BT/8852BE-VT */
{ IC_INFO(RTL_ROM_LMP_8852A, 0x87, 0xc, HCI_USB),
.config_needed = false,
@@ -655,6 +666,7 @@ static int rtlbt_parse_firmware(struct hci_dev *hdev,
{ RTL_ROM_LMP_8852A, 20 }, /* 8852B */
{ RTL_ROM_LMP_8852A, 25 }, /* 8852C */
{ RTL_ROM_LMP_8851B, 36 }, /* 8851B */
+ { RTL_ROM_LMP_8922A, 44 }, /* 8922A */
{ RTL_ROM_LMP_8852A, 47 }, /* 8852BT */
};
@@ -1255,6 +1267,7 @@ int btrtl_download_firmware(struct hci_dev *hdev,
case RTL_ROM_LMP_8852A:
case RTL_ROM_LMP_8703B:
case RTL_ROM_LMP_8851B:
+ case RTL_ROM_LMP_8922A:
err = btrtl_setup_rtl8723b(hdev, btrtl_dev);
break;
default:
@@ -1286,6 +1299,7 @@ void btrtl_set_quirks(struct hci_dev *hdev, struct btrtl_device_info *btrtl_dev)
case CHIP_ID_8852B:
case CHIP_ID_8852C:
case CHIP_ID_8851B:
+ case CHIP_ID_8922A:
case CHIP_ID_8852BT:
set_bit(HCI_QUIRK_VALID_LE_STATES, &hdev->quirks);
set_bit(HCI_QUIRK_WIDEBAND_SPEECH_SUPPORTED, &hdev->quirks);
@@ -1522,3 +1536,5 @@ MODULE_FIRMWARE("rtl_bt/rtl8852btu_config.bin");
MODULE_FIRMWARE("rtl_bt/rtl8852cu_fw.bin");
MODULE_FIRMWARE("rtl_bt/rtl8852cu_fw_v2.bin");
MODULE_FIRMWARE("rtl_bt/rtl8852cu_config.bin");
+MODULE_FIRMWARE("rtl_bt/rtl8922au_fw.bin");
+MODULE_FIRMWARE("rtl_bt/rtl8922au_config.bin");
diff --git a/drivers/bluetooth/btusb.c b/drivers/bluetooth/btusb.c
index 06e915b57283..d4aa9a84979b 100644
--- a/drivers/bluetooth/btusb.c
+++ b/drivers/bluetooth/btusb.c
@@ -556,6 +556,17 @@ static const struct usb_device_id quirks_table[] = {
/* Realtek 8852BT/8852BE-VT Bluetooth devices */
{ USB_DEVICE(0x0bda, 0x8520), .driver_info = BTUSB_REALTEK |
BTUSB_WIDEBAND_SPEECH },
+
+ /* Realtek 8922AE Bluetooth devices */
+ { USB_DEVICE(0x0bda, 0x8922), .driver_info = BTUSB_REALTEK |
+ BTUSB_WIDEBAND_SPEECH },
+ { USB_DEVICE(0x13d3, 0x3617), .driver_info = BTUSB_REALTEK |
+ BTUSB_WIDEBAND_SPEECH },
+ { USB_DEVICE(0x13d3, 0x3616), .driver_info = BTUSB_REALTEK |
+ BTUSB_WIDEBAND_SPEECH },
+ { USB_DEVICE(0x0489, 0xe130), .driver_info = BTUSB_REALTEK |
+ BTUSB_WIDEBAND_SPEECH },
+
/* Realtek Bluetooth devices */
{ USB_VENDOR_AND_INTERFACE_INFO(0x0bda, 0xe0, 0x01, 0x01),
.driver_info = BTUSB_REALTEK },
--
2.25.1
This is automated email and please do not reply to this email!
Dear submitter,
Thank you for submitting the patches to the linux bluetooth mailing list.
This is a CI test results with your patch series:
PW Link:https://patchwork.kernel.org/project/bluetooth/list/?series=834605
---Test result---
Test Summary:
CheckPatch PASS 0.84 seconds
GitLint PASS 0.33 seconds
SubjectPrefix PASS 0.12 seconds
BuildKernel PASS 27.96 seconds
CheckAllWarning PASS 30.66 seconds
CheckSparse PASS 35.95 seconds
CheckSmatch PASS 99.48 seconds
BuildKernel32 PASS 27.21 seconds
TestRunnerSetup PASS 511.01 seconds
TestRunner_l2cap-tester PASS 19.94 seconds
TestRunner_iso-tester PASS 28.20 seconds
TestRunner_bnep-tester PASS 4.78 seconds
TestRunner_mgmt-tester PASS 110.37 seconds
TestRunner_rfcomm-tester PASS 7.37 seconds
TestRunner_sco-tester PASS 15.01 seconds
TestRunner_ioctl-tester PASS 7.91 seconds
TestRunner_mesh-tester PASS 6.96 seconds
TestRunner_smp-tester PASS 6.85 seconds
TestRunner_userchan-tester PASS 4.99 seconds
IncrementalBuild PASS 26.33 seconds
---
Regards,
Linux Bluetooth