Hi,
I am faced with a problem, where-in my transport is UART and the hci0 interface from my driver (a TTY line discipline driver) is exposed @ boot time.
On Bluetooth-On, I perform a dev-up (or run bluetoothd/hcid which does that), how do I set the initialize my transport @ this point ?
I so desperately don't want to use hciattach, and want to allow my line discipline driver to do the firmware download (the reason why i have johan in CC) like the hci_h4p.
However, I would like to maintain my driver as a line discipline to avoid making use of primitive UART calls [like the hci_h4p].
Want to make use of DMA enabled, PM featured UART if available.
regards,
Pavan
The INTERNET now has a personality. YOURS! See your Yahoo! Homepage. http://in.yahoo.com/