From: Peter Chiu <[email protected]>
AQL requires tx rate for accurate counting, but it can't work well without
non-binding skb rate reporting when WED is enabled.
Co-developed-by: Ryder Lee <[email protected]>
Signed-off-by: Ryder Lee <[email protected]>
Signed-off-by: Peter Chiu <[email protected]>
---
drivers/net/wireless/mediatek/mt76/tx.c | 14 ++++++++++++++
1 file changed, 14 insertions(+)
diff --git a/drivers/net/wireless/mediatek/mt76/tx.c b/drivers/net/wireless/mediatek/mt76/tx.c
index 99d395bd1bba..37337595c65d 100644
--- a/drivers/net/wireless/mediatek/mt76/tx.c
+++ b/drivers/net/wireless/mediatek/mt76/tx.c
@@ -269,8 +269,22 @@ void __mt76_tx_complete_skb(struct mt76_dev *dev, u16 wcid_idx, struct sk_buff *
#endif
if (cb->pktid < MT_PACKET_ID_FIRST) {
+ struct ieee80211_tx_info *info = IEEE80211_SKB_CB(skb);
+ struct ieee80211_rate_status rs = {};
+
hw = mt76_tx_status_get_hw(dev, skb);
status.sta = wcid_to_sta(wcid);
+ if (mtk_wed_device_active(&dev->mmio.wed) &&
+ (info->flags & IEEE80211_TX_CTL_REQ_TX_STATUS)) {
+ info->status.rates[0].idx = -1;
+ if (status.sta && (wcid->rate.flags || wcid->rate.legacy)) {
+ rs.rate_idx = wcid->rate;
+ status.rates = &rs;
+ status.n_rates = 1;
+ } else {
+ status.n_rates = 0;
+ }
+ }
spin_lock_bh(&dev->rx_lock);
ieee80211_tx_status_ext(hw, &status);
spin_unlock_bh(&dev->rx_lock);
--
2.18.0