Currently the maximum noise floor limit is set as too high (-60dB). The
assumption of having a higher threshold limit is that it would help
de-sensitize the receiver (reduce phy errors) from continuous
interference. But when we have a bursty interference where there are
collisions and then free air time and if the receiver is desensitized too
much, it will miss the normal packets too. Lets make use of chips
specific min, nom and max limits always. This patch helps to improve the
connection stability in congested networks.
Cc: [email protected]
Cc: Paul Stewart <[email protected]>
Tested-by: Gary Morain <[email protected]>
Signed-off-by: Madhan Jaganathan <[email protected]>
Signed-off-by: Rajkumar Manoharan <[email protected]>
---
drivers/net/wireless/ath/ath9k/calib.c | 5 ++---
1 file changed, 2 insertions(+), 3 deletions(-)
diff --git a/drivers/net/wireless/ath/ath9k/calib.c b/drivers/net/wireless/ath/ath9k/calib.c
index 2f4b48e..e5cceb0 100644
--- a/drivers/net/wireless/ath/ath9k/calib.c
+++ b/drivers/net/wireless/ath/ath9k/calib.c
@@ -20,7 +20,6 @@
/* Common calibration code */
-#define ATH9K_NF_TOO_HIGH -60
static int16_t ath9k_hw_get_nf_hist_mid(int16_t *nfCalBuffer)
{
@@ -346,10 +345,10 @@ static void ath9k_hw_nf_sanitize(struct ath_hw *ah, s16 *nf)
"NF calibrated [%s] [chain %d] is %d\n",
(i >= 3 ? "ext" : "ctl"), i % 3, nf[i]);
- if (nf[i] > ATH9K_NF_TOO_HIGH) {
+ if (nf[i] > limit->max) {
ath_dbg(common, CALIBRATE,
"NF[%d] (%d) > MAX (%d), correcting to MAX\n",
- i, nf[i], ATH9K_NF_TOO_HIGH);
+ i, nf[i], limit->max);
nf[i] = limit->max;
} else if (nf[i] < limit->min) {
ath_dbg(common, CALIBRATE,
--
1.7.9.4