From: Mohammed Shafi Shajakhan <[email protected]>
We are doing MCI cleanup eventhough BTCOEX is not enabled
via module parameter. This means we do ath_mci_cleanup
though we skipped calling ath_mci_setup. Yet it does not
causes any issues now as we free the DMA buffer allocated
only when it is allocated during ath_mci_setup.
Reviewed-by: Bala Shanmugam <[email protected]>
Signed-off-by: Mohammed Shafi Shajakhan <[email protected]>
---
drivers/net/wireless/ath/ath9k/gpio.c | 4 +++-
1 files changed, 3 insertions(+), 1 deletions(-)
diff --git a/drivers/net/wireless/ath/ath9k/gpio.c b/drivers/net/wireless/ath/ath9k/gpio.c
index 5eac4d1..43557c2 100644
--- a/drivers/net/wireless/ath/ath9k/gpio.c
+++ b/drivers/net/wireless/ath/ath9k/gpio.c
@@ -387,11 +387,13 @@ void ath9k_stop_btcoex(struct ath_softc *sc)
void ath9k_deinit_btcoex(struct ath_softc *sc)
{
+ struct ath_hw *ah = sc->sc_ah;
+
if ((sc->btcoex.no_stomp_timer) &&
ath9k_hw_get_btcoex_scheme(sc->sc_ah) == ATH_BTCOEX_CFG_3WIRE)
ath_gen_timer_free(sc->sc_ah, sc->btcoex.no_stomp_timer);
- if (AR_SREV_9462(sc->sc_ah))
+ if (ath9k_hw_mci_is_enabled(ah))
ath_mci_cleanup(sc);
}
--
1.7.0.4