This will fix warnings like following when CONFIG_PM_SLEEP is not set:
warning: 'xxx_suspend' defined but not used [-Wunused-function]
warning: 'xxx_resume' defined but not used [-Wunused-function]
Because
SET_SYSTEM_SLEEP_PM_OPS(suspend_fn, resume_fn)
Only references the callbacks on CONFIG_PM_SLEEP (instead of CONFIG_PM).
Cc: John W. Linville <[email protected]>
Cc: "Rafał Miłecki" <[email protected]>
Cc: [email protected]
Signed-off-by: Yuanhan Liu <[email protected]>
Signed-off-by: Fengguang Wu <[email protected]>
---
drivers/bcma/host_pci.c | 6 +++---
1 files changed, 3 insertions(+), 3 deletions(-)
diff --git a/drivers/bcma/host_pci.c b/drivers/bcma/host_pci.c
index b6b4b5e..98fdc3e 100644
--- a/drivers/bcma/host_pci.c
+++ b/drivers/bcma/host_pci.c
@@ -238,7 +238,7 @@ static void __devexit bcma_host_pci_remove(struct pci_dev *dev)
pci_set_drvdata(dev, NULL);
}
-#ifdef CONFIG_PM
+#ifdef CONFIG_PM_SLEEP
static int bcma_host_pci_suspend(struct device *dev)
{
struct pci_dev *pdev = to_pci_dev(dev);
@@ -261,11 +261,11 @@ static SIMPLE_DEV_PM_OPS(bcma_pm_ops, bcma_host_pci_suspend,
bcma_host_pci_resume);
#define BCMA_PM_OPS (&bcma_pm_ops)
-#else /* CONFIG_PM */
+#else /* CONFIG_PM_SLEEP */
#define BCMA_PM_OPS NULL
-#endif /* CONFIG_PM */
+#endif /* CONFIG_PM_SLEEP */
static DEFINE_PCI_DEVICE_TABLE(bcma_pci_bridge_tbl) = {
{ PCI_DEVICE(PCI_VENDOR_ID_BROADCOM, 0x0576) },
--
1.7.7.6