Monitor mode is enabled by handling the filter flags we get from mac80211 in
rtl8xxxu_configure_filter() and writing them to the RCR register.
By handling the filters, we can also stop setting the BSSID filters in the
association event.
Signed-off-by: Bruno Randolf <[email protected]>
---
v2: Don't modify init table
---
drivers/net/wireless/realtek/rtl8xxxu/rtl8xxxu.c | 56 +++++++++++++++++++-----
1 file changed, 45 insertions(+), 11 deletions(-)
diff --git a/drivers/net/wireless/realtek/rtl8xxxu/rtl8xxxu.c b/drivers/net/wireless/realtek/rtl8xxxu/rtl8xxxu.c
index 11fcfda..0399b1e 100644
--- a/drivers/net/wireless/realtek/rtl8xxxu/rtl8xxxu.c
+++ b/drivers/net/wireless/realtek/rtl8xxxu/rtl8xxxu.c
@@ -4143,7 +4143,6 @@ static int rtl8xxxu_init_device(struct ieee80211_hw *hw)
* Configure initial WMAC settings
*/
val32 = RCR_ACCEPT_PHYS_MATCH | RCR_ACCEPT_MCAST | RCR_ACCEPT_BCAST |
- /* RCR_CHECK_BSSID_MATCH | RCR_CHECK_BSSID_BEACON | */
RCR_ACCEPT_MGMT_FRAME | RCR_HTC_LOC_CTRL |
RCR_APPEND_PHYSTAT | RCR_APPEND_ICV | RCR_APPEND_MIC;
rtl8xxxu_write32(priv, REG_RCR, val32);
@@ -4476,10 +4475,6 @@ rtl8xxxu_bss_info_changed(struct ieee80211_hw *hw, struct ieee80211_vif *vif,
rtl8xxxu_update_rate_mask(priv, ramask, sgi);
- val32 = rtl8xxxu_read32(priv, REG_RCR);
- val32 |= RCR_CHECK_BSSID_MATCH | RCR_CHECK_BSSID_BEACON;
- rtl8xxxu_write32(priv, REG_RCR, val32);
-
/* Enable RX of data frames */
rtl8xxxu_write16(priv, REG_RXFLTMAP2, 0xffff);
@@ -4493,11 +4488,6 @@ rtl8xxxu_bss_info_changed(struct ieee80211_hw *hw, struct ieee80211_vif *vif,
h2c.joinbss.data = H2C_JOIN_BSS_CONNECT;
} else {
- val32 = rtl8xxxu_read32(priv, REG_RCR);
- val32 &= ~(RCR_CHECK_BSSID_MATCH |
- RCR_CHECK_BSSID_BEACON);
- rtl8xxxu_write32(priv, REG_RCR, val32);
-
val8 = rtl8xxxu_read8(priv, REG_BEACON_CTRL);
val8 |= BEACON_DISABLE_TSF_UPDATE;
rtl8xxxu_write8(priv, REG_BEACON_CTRL, val8);
@@ -5272,11 +5262,55 @@ static void rtl8xxxu_configure_filter(struct ieee80211_hw *hw,
unsigned int *total_flags, u64 multicast)
{
struct rtl8xxxu_priv *priv = hw->priv;
+ u32 rcr = rtl8xxxu_read32(priv, REG_RCR);
dev_dbg(&priv->udev->dev, "%s: changed_flags %08x, total_flags %08x\n",
__func__, changed_flags, *total_flags);
- *total_flags &= (FIF_ALLMULTI | FIF_CONTROL | FIF_BCN_PRBRESP_PROMISC);
+ /*
+ * FIF_ALLMULTI ignored as all multicast frames are accepted (REG_MAR)
+ */
+
+ if (*total_flags & FIF_FCSFAIL)
+ rcr |= RCR_ACCEPT_CRC32;
+ else
+ rcr &= ~RCR_ACCEPT_CRC32;
+
+ /*
+ * FIF_PLCPFAIL not supported?
+ */
+
+ if (*total_flags & FIF_BCN_PRBRESP_PROMISC)
+ rcr &= ~RCR_CHECK_BSSID_BEACON;
+ else
+ rcr |= RCR_CHECK_BSSID_BEACON;
+
+ if (*total_flags & FIF_CONTROL)
+ rcr |= RCR_ACCEPT_CTRL_FRAME;
+ else
+ rcr &= ~RCR_ACCEPT_CTRL_FRAME;
+
+ if (*total_flags & FIF_OTHER_BSS) {
+ rcr |= RCR_ACCEPT_AP;
+ rcr &= ~RCR_CHECK_BSSID_MATCH;
+ } else {
+ rcr &= ~RCR_ACCEPT_AP;
+ rcr |= RCR_CHECK_BSSID_MATCH;
+ }
+
+ if (*total_flags & FIF_PSPOLL)
+ rcr |= RCR_ACCEPT_PM;
+ else
+ rcr &= ~RCR_ACCEPT_PM;
+
+ /*
+ * FIF_PROBE_REQ ignored as probe requests always seem to be accepted
+ */
+
+ rtl8xxxu_write32(priv, REG_RCR, rcr);
+
+ *total_flags &= (FIF_ALLMULTI | FIF_FCSFAIL | FIF_BCN_PRBRESP_PROMISC | \
+ FIF_CONTROL | FIF_OTHER_BSS | FIF_PSPOLL | FIF_PROBE_REQ);
}
static int rtl8xxxu_set_rts_threshold(struct ieee80211_hw *hw, u32 rts)
--
1.9.1