From: Tamizh chelvam <[email protected]>
There two things done in this patch.
1) 'btcoex_support' flag for BTCOEX feature support by the hardware.
2) 'wlan_btcoex_gpio' is used to fill wlan priority pin number for
BTCOEX priority feature support.
Signed-off-by: Tamizh chelvam <[email protected]>
---
.../bindings/net/wireless/qcom,ath10k.txt | 4 ++++
1 file changed, 4 insertions(+)
diff --git a/Documentation/devicetree/bindings/net/wireless/qcom,ath10k.txt b/Documentation/devicetree/bindings/net/wireless/qcom,ath10k.txt
index 74d7f0a..08150e2d 100644
--- a/Documentation/devicetree/bindings/net/wireless/qcom,ath10k.txt
+++ b/Documentation/devicetree/bindings/net/wireless/qcom,ath10k.txt
@@ -46,6 +46,10 @@ Optional properties:
hw versions.
- qcom,ath10k-pre-calibration-data : pre calibration data as an array,
the length can vary between hw versions.
+- btcoex_support : should contain eithr "0" or "1" to indicate btcoex
+ support by the hardware.
+- btcoex_gpio_pin : btcoex gpio pin number for the device which
+ supports BTCOEX.
Example (to supply the calibration data alone):
--
1.7.9.5
(Adding devicetree list)
<[email protected]> writes:
> From: Tamizh chelvam <[email protected]>
>
> There two things done in this patch.
>
> 1) 'btcoex_support' flag for BTCOEX feature support by the hardware.
> 2) 'wlan_btcoex_gpio' is used to fill wlan priority pin number for
> BTCOEX priority feature support.
>
> Signed-off-by: Tamizh chelvam <[email protected]>
> ---
> .../bindings/net/wireless/qcom,ath10k.txt | 4 ++++
> 1 file changed, 4 insertions(+)
As this changes the device tree bindings you need to CC the device tree
list. Please resend the whole patchset (and mark it as v2).
--=20
Kalle Valo=