From: Tamizh chelvam <[email protected]>
Rx filter reset and the dynamic tx switch mode (EXT_RESOURCE_CFG)
configuration are causing the following errors when UTF firmware
is loaded to the target.
Error message 1:
[ 598.015629] ath10k_pci 0001:01:00.0: failed to ping firmware: -110
[ 598.020828] ath10k_pci 0001:01:00.0: failed to reset rx filter: -110
[ 598.141556] ath10k_pci 0001:01:00.0: failed to start core (testmode): -110
Error message 2:
[ 668.615839] ath10k_ahb a000000.wifi: failed to send ext resource cfg command : -95
[ 668.618902] ath10k_ahb a000000.wifi: failed to start core (testmode): -95
Avoiding these configurations while bringing the target in
testmode is solving the problem.
Signed-off-by: Tamizh chelvam <[email protected]>
---
drivers/net/wireless/ath/ath10k/core.c | 14 +++++++++-----
1 file changed, 9 insertions(+), 5 deletions(-)
diff --git a/drivers/net/wireless/ath/ath10k/core.c b/drivers/net/wireless/ath/ath10k/core.c
index 874c2a7..0d12761 100644
--- a/drivers/net/wireless/ath/ath10k/core.c
+++ b/drivers/net/wireless/ath/ath10k/core.c
@@ -1922,7 +1922,8 @@ int ath10k_core_start(struct ath10k *ar, enum ath10k_firmware_mode mode,
ath10k_dbg(ar, ATH10K_DBG_BOOT, "firmware %s booted\n",
ar->hw->wiphy->fw_version);
- if (test_bit(WMI_SERVICE_EXT_RES_CFG_SUPPORT, ar->wmi.svc_map)) {
+ if (test_bit(WMI_SERVICE_EXT_RES_CFG_SUPPORT, ar->wmi.svc_map) &&
+ mode == ATH10K_FIRMWARE_MODE_NORMAL) {
val = 0;
if (ath10k_peer_stats_enabled(ar))
val = WMI_10_4_PEER_STATS;
@@ -1975,10 +1976,13 @@ int ath10k_core_start(struct ath10k *ar, enum ath10k_firmware_mode mode,
* possible to implicitly make it correct by creating a dummy vdev and
* then deleting it.
*/
- status = ath10k_core_reset_rx_filter(ar);
- if (status) {
- ath10k_err(ar, "failed to reset rx filter: %d\n", status);
- goto err_hif_stop;
+ if (mode == ATH10K_FIRMWARE_MODE_NORMAL) {
+ status = ath10k_core_reset_rx_filter(ar);
+ if (status) {
+ ath10k_err(ar,
+ "failed to reset rx filter: %d\n", status);
+ goto err_hif_stop;
+ }
}
/* If firmware indicates Full Rx Reorder support it must be used in a
--
1.7.9.5