Channel active/busy time are showing incorrect(less than previous or
sometimes zero) for successive survey dump command.
example:
Survey data from wlan0
frequency: 5180 MHz [in use]
channel active time: 54995 ms
channel busy time: 432 ms
channel receive time: 0 ms
channel transmit time: 59 ms
Survey data from wlan0
frequency: 5180 MHz [in use]
channel active time: 32592 ms
channel busy time: 254 ms
channel receive time: 0 ms
channel transmit time: 0 ms
This patch fix this issue by assigning 'wmi_bss_survey_req_type'
as 'WMI_BSS_SURVEY_REQ_TYPE_READ' which accumulate survey data in
FW and send survey data to driver upon the driver request. Wrap around
is taken care by FW.
hardware used : QCA9984
firmware ver : ver 10.4-3.5.3-00057
hardware used : QCA988X
firmware ver : 10.2.4-1.0-00047
Tested-by: Markus Theil <[email protected]>
Signed-off-by: Markus Theil <[email protected]>
Signed-off-by: Venkateswara Naralasetty <[email protected]>
---
v3:
* Rebased on TOT and added Tested-by
drivers/net/wireless/ath/ath10k/mac.c | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)
diff --git a/drivers/net/wireless/ath/ath10k/mac.c b/drivers/net/wireless/ath/ath10k/mac.c
index a1147cc..9330b52 100644
--- a/drivers/net/wireless/ath/ath10k/mac.c
+++ b/drivers/net/wireless/ath/ath10k/mac.c
@@ -7275,7 +7275,7 @@ ath10k_mac_update_bss_chan_survey(struct ath10k *ar,
struct ieee80211_channel *channel)
{
int ret;
- enum wmi_bss_survey_req_type type = WMI_BSS_SURVEY_REQ_TYPE_READ_CLEAR;
+ enum wmi_bss_survey_req_type type = WMI_BSS_SURVEY_REQ_TYPE_READ;
lockdep_assert_held(&ar->conf_mutex);
--
2.7.4