driver not able to bootup in the single radio configured board.
single phy hw mode is converted to invalid hw mode and sent to FW
through wmi init cmd. In that case driver is not receiving wmi
ready event which leads to driver bootup fail. single phy hw mode
is a valid for single radio configured board. so removed the
conversion logic.
Tested-on: IPQ8074 hw2.0 AHB WLAN.HK.2.1.0.1-01238-QCAHKSWPL_SILICONZ-2
Signed-off-by: Karthikeyan Periyasamy <[email protected]>
---
drivers/net/wireless/ath/ath11k/wmi.c | 3 ---
1 file changed, 3 deletions(-)
diff --git a/drivers/net/wireless/ath/ath11k/wmi.c b/drivers/net/wireless/ath/ath11k/wmi.c
index 6e17373..1f0c517 100644
--- a/drivers/net/wireless/ath/ath11k/wmi.c
+++ b/drivers/net/wireless/ath/ath11k/wmi.c
@@ -3351,9 +3351,6 @@ int ath11k_wmi_cmd_init(struct ath11k_base *ab)
init_param.hw_mode_id = wmi_sc->preferred_hw_mode;
init_param.mem_chunks = wmi_sc->mem_chunks;
- if (wmi_sc->preferred_hw_mode == WMI_HOST_HW_MODE_SINGLE)
- init_param.hw_mode_id = WMI_HOST_HW_MODE_MAX;
-
if (ab->hw_params.needs_band_to_mac) {
init_param.num_band_to_mac = ab->num_radios;
ath11k_fill_band_to_mac_param(ab, init_param.band_to_mac);
--
2.7.4
Karthikeyan Periyasamy <[email protected]> wrote:
> driver not able to bootup in the single radio configured board.
> single phy hw mode is converted to invalid hw mode and sent to FW
> through wmi init cmd. In that case driver is not receiving wmi
> ready event which leads to driver bootup fail. single phy hw mode
> is a valid for single radio configured board. so removed the
> conversion logic.
>
> Tested-on: IPQ8074 hw2.0 AHB WLAN.HK.2.1.0.1-01238-QCAHKSWPL_SILICONZ-2
>
> Signed-off-by: Karthikeyan Periyasamy <[email protected]>
> Signed-off-by: Kalle Valo <[email protected]>
Patch applied to ath-next branch of ath.git, thanks.
9fb13b81e145 ath11k: Fix single phy hw mode
--
https://patchwork.kernel.org/project/linux-wireless/patch/[email protected]/
https://wireless.wiki.kernel.org/en/developers/documentation/submittingpatches