Add support to configure the beacon tx mode in
the driver.
Beacons can be sent out in burst(continuously in a single shot
one after another) or staggered (equally spread out over beacon
interval) mode.
Use the below configuration in the hostapd/wpa_supplicant
for AP/MESH mode to configure the beacon tx mode.
"beacon_tx_mode=N", where N = 1 for STAGGERED beacon mode
and N = 2 for BURST beacon mode.
Tested-on: IPQ8074 hw2.0 AHB WLAN.HK.2.5.0.1-00480-QCAHKSWPL_SILICONZ-1
Signed-off-by: Maharaja Kennadyrajan <[email protected]>
---
drivers/net/wireless/ath/ath11k/mac.c | 10 +++++++---
1 file changed, 7 insertions(+), 3 deletions(-)
diff --git a/drivers/net/wireless/ath/ath11k/mac.c b/drivers/net/wireless/ath/ath11k/mac.c
index 9d0ff15..dfc8644 100644
--- a/drivers/net/wireless/ath/ath11k/mac.c
+++ b/drivers/net/wireless/ath/ath11k/mac.c
@@ -2130,7 +2130,10 @@ static void ath11k_mac_op_bss_info_changed(struct ieee80211_hw *hw,
if (changed & BSS_CHANGED_BEACON) {
param_id = WMI_PDEV_PARAM_BEACON_TX_MODE;
- param_value = WMI_BEACON_STAGGERED_MODE;
+ if (info->beacon_tx_mode == NL80211_BEACON_BURST_MODE)
+ param_value = WMI_BEACON_BURST_MODE;
+ else
+ param_value = WMI_BEACON_STAGGERED_MODE;
ret = ath11k_wmi_pdev_set_param(ar, param_id,
param_value, ar->pdev->pdev_id);
if (ret)
@@ -2138,8 +2141,9 @@ static void ath11k_mac_op_bss_info_changed(struct ieee80211_hw *hw,
arvif->vdev_id);
else
ath11k_dbg(ar->ab, ATH11K_DBG_MAC,
- "Set staggered beacon mode for VDEV: %d\n",
- arvif->vdev_id);
+ "Set %s beacon mode for VDEV: %d mode: %d\n",
+ param_value ? "burst" : "staggered",
+ arvif->vdev_id, param_value);
ret = ath11k_mac_setup_bcn_tmpl(arvif);
if (ret)
--
2.7.4