AR9285 based devices support only single stream MCS rates.
This patch fixes a bug where dual stream stream rates were
also being registered.
Signed-off-by: Sujith <[email protected]>
---
drivers/net/wireless/ath9k/main.c | 23 ++++++++++++++++++-----
1 files changed, 18 insertions(+), 5 deletions(-)
diff --git a/drivers/net/wireless/ath9k/main.c b/drivers/net/wireless/ath9k/main.c
index 8ad927a..4ff266b 100644
--- a/drivers/net/wireless/ath9k/main.c
+++ b/drivers/net/wireless/ath9k/main.c
@@ -860,7 +860,8 @@ static void ath_key_delete(struct ath_softc *sc, struct ieee80211_key_conf *key)
}
}
-static void setup_ht_cap(struct ieee80211_sta_ht_cap *ht_info)
+static void setup_ht_cap(struct ath_softc *sc,
+ struct ieee80211_sta_ht_cap *ht_info)
{
#define ATH9K_HT_CAP_MAXRXAMPDU_65536 0x3 /* 2 ^ 16 */
#define ATH9K_HT_CAP_MPDUDENSITY_8 0x6 /* 8 usec */
@@ -873,10 +874,22 @@ static void setup_ht_cap(struct ieee80211_sta_ht_cap *ht_info)
ht_info->ampdu_factor = ATH9K_HT_CAP_MAXRXAMPDU_65536;
ht_info->ampdu_density = ATH9K_HT_CAP_MPDUDENSITY_8;
+
/* set up supported mcs set */
memset(&ht_info->mcs, 0, sizeof(ht_info->mcs));
- ht_info->mcs.rx_mask[0] = 0xff;
- ht_info->mcs.rx_mask[1] = 0xff;
+
+ switch(sc->sc_rx_chainmask) {
+ case 1:
+ ht_info->mcs.rx_mask[0] = 0xff;
+ break;
+ case 5:
+ case 7:
+ default:
+ ht_info->mcs.rx_mask[0] = 0xff;
+ ht_info->mcs.rx_mask[1] = 0xff;
+ break;
+ }
+
ht_info->mcs.tx_params = IEEE80211_HT_MCS_TX_DEFINED;
}
@@ -1545,9 +1558,9 @@ int ath_attach(u16 devid, struct ath_softc *sc)
hw->rate_control_algorithm = "ath9k_rate_control";
if (sc->sc_ah->ah_caps.hw_caps & ATH9K_HW_CAP_HT) {
- setup_ht_cap(&sc->sbands[IEEE80211_BAND_2GHZ].ht_cap);
+ setup_ht_cap(sc, &sc->sbands[IEEE80211_BAND_2GHZ].ht_cap);
if (test_bit(ATH9K_MODE_11A, sc->sc_ah->ah_caps.wireless_modes))
- setup_ht_cap(&sc->sbands[IEEE80211_BAND_5GHZ].ht_cap);
+ setup_ht_cap(sc, &sc->sbands[IEEE80211_BAND_5GHZ].ht_cap);
}
hw->wiphy->bands[IEEE80211_BAND_2GHZ] = &sc->sbands[IEEE80211_BAND_2GHZ];
--
1.6.1