The various ANI timers have to be initialized properly when
starting the calibration timer.
Cc: [email protected]
Signed-off-by: Sujith <[email protected]>
---
drivers/net/wireless/ath/ath9k/main.c | 24 +++++++++++++++---------
1 files changed, 15 insertions(+), 9 deletions(-)
diff --git a/drivers/net/wireless/ath/ath9k/main.c b/drivers/net/wireless/ath/ath9k/main.c
index b2d129f..9564b73 100644
--- a/drivers/net/wireless/ath/ath9k/main.c
+++ b/drivers/net/wireless/ath/ath9k/main.c
@@ -407,6 +407,18 @@ set_timer:
mod_timer(&sc->ani.timer, jiffies + msecs_to_jiffies(cal_interval));
}
+static void ath_start_ani(struct ath_softc *sc)
+{
+ unsigned long timestamp = jiffies_to_msecs(jiffies);
+
+ sc->ani.longcal_timer = timestamp;
+ sc->ani.shortcal_timer = timestamp;
+ sc->ani.checkani_timer = timestamp;
+
+ mod_timer(&sc->ani.timer,
+ jiffies + msecs_to_jiffies(ATH_ANI_POLLINTERVAL));
+}
+
/*
* Update tx/rx chainmask. For legacy association,
* hard code chainmask to 1x1, for 11n association, use
@@ -911,9 +923,7 @@ static void ath9k_bss_assoc_info(struct ath_softc *sc,
sc->nodestats.ns_avgtxrssi = ATH_RSSI_DUMMY_MARKER;
sc->nodestats.ns_avgtxrate = ATH_RATE_DUMMY_MARKER;
- /* Start ANI */
- mod_timer(&sc->ani.timer,
- jiffies + msecs_to_jiffies(ATH_ANI_POLLINTERVAL));
+ ath_start_ani(sc);
} else {
DPRINTF(sc, ATH_DBG_CONFIG, "Bss Info DISASSOC\n");
sc->curaid = 0;
@@ -2239,12 +2249,8 @@ static int ath9k_add_interface(struct ieee80211_hw *hw,
ath9k_hw_set_interrupts(sc->sc_ah, sc->imask);
- if (conf->type == NL80211_IFTYPE_AP) {
- /* TODO: is this a suitable place to start ANI for AP mode? */
- /* Start ANI */
- mod_timer(&sc->ani.timer,
- jiffies + msecs_to_jiffies(ATH_ANI_POLLINTERVAL));
- }
+ if (conf->type == NL80211_IFTYPE_AP)
+ ath_start_ani(sc);
out:
mutex_unlock(&sc->mutex);
--
1.6.2.2