Currently, PAE frames are not assigned proper sequence numbers.
Since sending PAE frames as part of aggregates breaks
crupto with several APs, they are sent as normal MPDUs.
Fix the seqeuence number issue by updating the frame with the
internal sequence number.
Tested-by: Felix Fietkau <[email protected]>
Signed-off-by: Sujith <[email protected]>
Cc: [email protected]
---
drivers/net/wireless/ath/ath9k/xmit.c | 4 ++--
1 files changed, 2 insertions(+), 2 deletions(-)
diff --git a/drivers/net/wireless/ath/ath9k/xmit.c b/drivers/net/wireless/ath/ath9k/xmit.c
index f5cbbcb..47294f9 100644
--- a/drivers/net/wireless/ath/ath9k/xmit.c
+++ b/drivers/net/wireless/ath/ath9k/xmit.c
@@ -1610,7 +1610,7 @@ static int ath_tx_setup_buffer(struct ieee80211_hw *hw, struct ath_buf *bf,
bf->bf_frmlen -= padsize;
}
- if (conf_is_ht(&hw->conf) && !is_pae(skb))
+ if (conf_is_ht(&hw->conf))
bf->bf_state.bf_type |= BUF_HT;
bf->bf_flags = setup_tx_flags(sc, skb, txctl->txq);
@@ -1696,7 +1696,7 @@ static void ath_tx_start_dma(struct ath_softc *sc, struct ath_buf *bf,
goto tx_done;
}
- if (tx_info->flags & IEEE80211_TX_CTL_AMPDU) {
+ if ((tx_info->flags & IEEE80211_TX_CTL_AMPDU) && !is_pae(skb)) {
/*
* Try aggregation if it's a unicast data frame
* and the destination is HT capable.
--
1.6.6.1