if(!wait_for_completion_interruptible_timeout(...))
only handles the timeout case - this patch adds handling the
signal case the same as timeout.
Signed-off-by: Nicholas Mc Guire <[email protected]>
---
Only the timeout case was being handled, the signal case
(-ERESTARTSYS) was treated just like the case of successful
completion, which is most likely not reasonable.
The callsite for p54p_open() in p54p_firmware_step2() expect !=0 to
indicate error so both -ERESTARTSYS and -ETIMEDOUT should be fine
for the current handling.
Patch was only compild tested with x86_64_defcofnig +
CONFIG_P54_COMMON=m, CONFIG_P54_PCI=m
Patch is against 3.19.0-rc5 -next-20150119
drivers/net/wireless/p54/p54pci.c | 7 +++++--
1 file changed, 5 insertions(+), 2 deletions(-)
diff --git a/drivers/net/wireless/p54/p54pci.c b/drivers/net/wireless/p54/p54pci.c
index d4aee64..27a4906 100644
--- a/drivers/net/wireless/p54/p54pci.c
+++ b/drivers/net/wireless/p54/p54pci.c
@@ -431,6 +431,7 @@ static int p54p_open(struct ieee80211_hw *dev)
{
struct p54p_priv *priv = dev->priv;
int err;
+ long timeout;
init_completion(&priv->boot_comp);
err = request_irq(priv->pdev->irq, p54p_interrupt,
@@ -468,10 +469,12 @@ static int p54p_open(struct ieee80211_hw *dev)
P54P_WRITE(dev_int, cpu_to_le32(ISL38XX_DEV_INT_RESET));
P54P_READ(dev_int);
- if (!wait_for_completion_interruptible_timeout(&priv->boot_comp, HZ)) {
+ timeout = wait_for_completion_interruptible_timeout(
+ &priv->boot_comp, HZ);
+ if (timeout <= 0) {
wiphy_err(dev->wiphy, "Cannot boot firmware!\n");
p54p_stop(dev);
- return -ETIMEDOUT;
+ return timeout ? -ERESTARTSYS : -ETIMEDOUT;
}
P54P_WRITE(int_enable, cpu_to_le32(ISL38XX_INT_IDENT_UPDATE));
--
1.7.10.4
> if(!wait_for_completion_interruptible_timeout(...))
> only handles the timeout case - this patch adds handling the
> signal case the same as timeout.
>
> Signed-off-by: Nicholas Mc Guire <[email protected]>
> Acked-by: Christian Lamparter <[email protected]>
Thanks, applied to wireless-drivers-next.git. I remove the useless "wireless: "
from the title.
Kalle Valo
On Tuesday, January 20, 2015 06:26:17 AM Nicholas Mc Guire wrote:
> if(!wait_for_completion_interruptible_timeout(...))
> only handles the timeout case - this patch adds handling the
> signal case the same as timeout.
>
> Signed-off-by: Nicholas Mc Guire <[email protected]>
Acked-by: Christian Lamparter <[email protected]>