Do not alter the tx/rx chain settings during channel setup, antennas are
remapped by the testmode specific register writes already
Signed-off-by: Felix Fietkau <[email protected]>
---
drivers/net/wireless/mediatek/mt76/mt7615/mcu.c | 8 --------
drivers/net/wireless/mediatek/mt76/mt7615/testmode.c | 2 +-
2 files changed, 1 insertion(+), 9 deletions(-)
diff --git a/drivers/net/wireless/mediatek/mt76/mt7615/mcu.c b/drivers/net/wireless/mediatek/mt76/mt7615/mcu.c
index 074cdefba8aa..967c0e80a4a8 100644
--- a/drivers/net/wireless/mediatek/mt76/mt7615/mcu.c
+++ b/drivers/net/wireless/mediatek/mt76/mt7615/mcu.c
@@ -2850,14 +2850,6 @@ int mt7615_mcu_set_chan_info(struct mt7615_phy *phy, int cmd)
.center_chan2 = ieee80211_frequency_to_channel(freq2),
};
-#ifdef CONFIG_NL80211_TESTMODE
- if (dev->mt76.test.state == MT76_TM_STATE_TX_FRAMES &&
- dev->mt76.test.tx_antenna_mask) {
- req.tx_streams = hweight8(dev->mt76.test.tx_antenna_mask);
- req.rx_streams_mask = dev->mt76.test.tx_antenna_mask;
- }
-#endif
-
if (dev->mt76.hw->conf.flags & IEEE80211_CONF_OFFCHANNEL)
req.switch_reason = CH_SWITCH_SCAN_BYPASS_DPD;
else if ((chandef->chan->flags & IEEE80211_CHAN_RADAR) &&
diff --git a/drivers/net/wireless/mediatek/mt76/mt7615/testmode.c b/drivers/net/wireless/mediatek/mt76/mt7615/testmode.c
index 2cfa58d49832..1a67c244e96f 100644
--- a/drivers/net/wireless/mediatek/mt76/mt7615/testmode.c
+++ b/drivers/net/wireless/mediatek/mt76/mt7615/testmode.c
@@ -193,7 +193,7 @@ mt7615_tm_set_tx_antenna(struct mt7615_dev *dev, bool en)
for (i = 0; i < 4; i++) {
mt76_rmw_field(dev, MT_WF_PHY_RFINTF3_0(i),
MT_WF_PHY_RFINTF3_0_ANT,
- td->tx_antenna_mask & BIT(i) ? 0 : 0xa);
+ (td->tx_antenna_mask & BIT(i)) ? 0 : 0xa);
}
--
2.28.0