Typically all AP interfaces on a PHY will share the same WMM settings, while
sta/mesh interfaces will usually inherit the settings from a remote device.
In order minimize the likelihood of conflicting WMM settings, make all AP
interfaces share one slot, and all non-AP interfaces another one.
Signed-off-by: Felix Fietkau <[email protected]>
---
drivers/net/wireless/mediatek/mt76/mt7915/main.c | 8 +++-----
1 file changed, 3 insertions(+), 5 deletions(-)
diff --git a/drivers/net/wireless/mediatek/mt76/mt7915/main.c b/drivers/net/wireless/mediatek/mt76/mt7915/main.c
index 057ab27b7083..8c1fa08b6286 100644
--- a/drivers/net/wireless/mediatek/mt76/mt7915/main.c
+++ b/drivers/net/wireless/mediatek/mt76/mt7915/main.c
@@ -218,11 +218,9 @@ static int mt7915_add_interface(struct ieee80211_hw *hw,
mvif->phy = phy;
mvif->band_idx = ext_phy;
- if (dev->mt76.phy2)
- mvif->wmm_idx = ext_phy * (MT7915_MAX_WMM_SETS / 2) +
- mvif->idx % (MT7915_MAX_WMM_SETS / 2);
- else
- mvif->wmm_idx = mvif->idx % MT7915_MAX_WMM_SETS;
+ mvif->wmm_idx = vif->type != NL80211_IFTYPE_AP;
+ if (ext_phy)
+ mvif->wmm_idx += 2;
ret = mt7915_mcu_add_dev_info(phy, vif, true);
if (ret)
--
2.30.1