During firmware recovery, the monitor interface is not
getting created in the driver and firmware since
the respective flags are not updated properly.
So after firmware recovery is successful, when monitor
interface is brought down manually, firmware assertion
is observed, since we are trying to bring down the
interface which is not yet created in the firmware.
Fix this by updating the monitor flags properly per
phy#, during firmware recovery.
Tested-on: IPQ8074 hw2.0 AHB WLAN.HK.2.7.0.1-01744-QCAHKSWPL_SILICONZ-1
Signed-off-by: Nagarajan Maran <[email protected]>
---
drivers/net/wireless/ath/ath11k/core.c | 4 ++++
1 file changed, 4 insertions(+)
diff --git a/drivers/net/wireless/ath/ath11k/core.c b/drivers/net/wireless/ath/ath11k/core.c
index 35a5de3a0a8a..0ab2f190f1ec 100644
--- a/drivers/net/wireless/ath/ath11k/core.c
+++ b/drivers/net/wireless/ath/ath11k/core.c
@@ -1677,6 +1677,10 @@ void ath11k_core_pre_reconfigure_recovery(struct ath11k_base *ab)
ath11k_mac_tx_mgmt_pending_free, ar);
idr_destroy(&ar->txmgmt_idr);
wake_up(&ar->txmgmt_empty_waitq);
+
+ ar->monitor_vdev_id = -1;
+ clear_bit(ATH11K_FLAG_MONITOR_STARTED, &ar->monitor_flags);
+ clear_bit(ATH11K_FLAG_MONITOR_VDEV_CREATED, &ar->monitor_flags);
}
wake_up(&ab->wmi_ab.tx_credits_wq);
--
2.17.1