2023-09-28 16:08:43

by Greenman, Gregory

[permalink] [raw]
Subject: [PATCH 09/18] wifi: cfg80211: Handle specific BSSID in 6GHz scanning

From: Ilan Peer <[email protected]>

When the scan parameters for a 6GHz scan specify a unicast
BSSID address, and the corresponding AP is found in the scan
list, add a corresponding entry in the collocated AP list,
so this AP would be directly probed even if it was not
advertised as a collocated AP.

This is needed for handling a scan request that is intended
for a ML probe flow, where user space can requests a scan
to retrieve information for other links in the AP MLD.

Signed-off-by: Ilan Peer <[email protected]>
Signed-off-by: Gregory Greenman <[email protected]>
---
net/wireless/scan.c | 37 +++++++++++++++++++++++++++++++++++++
1 file changed, 37 insertions(+)

diff --git a/net/wireless/scan.c b/net/wireless/scan.c
index 8d114faf4842..6c2acd3fa36a 100644
--- a/net/wireless/scan.c
+++ b/net/wireless/scan.c
@@ -830,10 +830,47 @@ static int cfg80211_scan_6ghz(struct cfg80211_registered_device *rdev)
list_for_each_entry(intbss, &rdev->bss_list, list) {
struct cfg80211_bss *res = &intbss->pub;
const struct cfg80211_bss_ies *ies;
+ const struct element *ssid_elem;
+ struct cfg80211_colocated_ap *entry;
+ u32 s_ssid_tmp;
+ int ret;

ies = rcu_access_pointer(res->ies);
count += cfg80211_parse_colocated_ap(ies,
&coloc_ap_list);
+
+ /* In case the scan request specified a specific BSSID
+ * and the BSS is found and operating on 6GHz band then
+ * add this AP to the collocated APs list.
+ * This is relevant for ML probe requests when the lower
+ * band APs have not been discovered.
+ */
+ if (is_broadcast_ether_addr(rdev_req->bssid) ||
+ !ether_addr_equal(rdev_req->bssid, res->bssid) ||
+ res->channel->band != NL80211_BAND_6GHZ)
+ continue;
+
+ ret = cfg80211_calc_short_ssid(ies, &ssid_elem,
+ &s_ssid_tmp);
+ if (ret)
+ continue;
+
+ entry = kzalloc(sizeof(*entry) + IEEE80211_MAX_SSID_LEN,
+ GFP_ATOMIC);
+
+ if (!entry)
+ continue;
+
+ memcpy(entry->bssid, res->bssid, ETH_ALEN);
+ entry->short_ssid = s_ssid_tmp;
+ memcpy(entry->ssid, ssid_elem->data,
+ ssid_elem->datalen);
+ entry->ssid_len = ssid_elem->datalen;
+ entry->short_ssid_valid = true;
+ entry->center_freq = res->channel->center_freq;
+
+ list_add_tail(&entry->list, &coloc_ap_list);
+ count++;
}
spin_unlock_bh(&rdev->bss_lock);
}
--
2.38.1