From: Quan Zhou <[email protected]>
For some cases as below, we may encounter the unpreditable chip stats
in driver probe()
* The system reboot flow do not work properly, such as kernel oops while
rebooting, and then the driver do not go back to default status at
this moment.
* Similar to the flow above. If the device was enabled in BIOS or UEFI,
the system may switch to Linux without driver fully shutdown.
To avoid the problem, force push the device back to default in probe()
* mt7921e_mcu_fw_pmctrl() : return control privilege to chip side.
* mt7921_wfsys_reset() : cleanup chip config before resource init.
Error log
[59007.600714] mt7921e 0000:02:00.0: ASIC revision: 79220010
[59010.889773] mt7921e 0000:02:00.0: Message 00000010 (seq 1) timeout
[59010.889786] mt7921e 0000:02:00.0: Failed to get patch semaphore
[59014.217839] mt7921e 0000:02:00.0: Message 00000010 (seq 2) timeout
[59014.217852] mt7921e 0000:02:00.0: Failed to get patch semaphore
[59017.545880] mt7921e 0000:02:00.0: Message 00000010 (seq 3) timeout
[59017.545893] mt7921e 0000:02:00.0: Failed to get patch semaphore
[59020.874086] mt7921e 0000:02:00.0: Message 00000010 (seq 4) timeout
[59020.874099] mt7921e 0000:02:00.0: Failed to get patch semaphore
[59024.202019] mt7921e 0000:02:00.0: Message 00000010 (seq 5) timeout
[59024.202033] mt7921e 0000:02:00.0: Failed to get patch semaphore
[59027.530082] mt7921e 0000:02:00.0: Message 00000010 (seq 6) timeout
[59027.530096] mt7921e 0000:02:00.0: Failed to get patch semaphore
[59030.857888] mt7921e 0000:02:00.0: Message 00000010 (seq 7) timeout
[59030.857904] mt7921e 0000:02:00.0: Failed to get patch semaphore
[59034.185946] mt7921e 0000:02:00.0: Message 00000010 (seq 8) timeout
[59034.185961] mt7921e 0000:02:00.0: Failed to get patch semaphore
[59037.514249] mt7921e 0000:02:00.0: Message 00000010 (seq 9) timeout
[59037.514262] mt7921e 0000:02:00.0: Failed to get patch semaphore
[59040.842362] mt7921e 0000:02:00.0: Message 00000010 (seq 10) timeout
[59040.842375] mt7921e 0000:02:00.0: Failed to get patch semaphore
[59040.923845] mt7921e 0000:02:00.0: hardware init failed
Cc: [email protected]
Fixes: 5c14a5f944b9 ("mt76: mt7921: introduce mt7921e support")
Tested-by: Kai-Heng Feng <[email protected]>
Tested-by: Juan Martinez <[email protected]>
Co-developed-by: Leon Yen <[email protected]>
Signed-off-by: Leon Yen <[email protected]>
Signed-off-by: Quan Zhou <[email protected]>
Signed-off-by: Deren Wu <[email protected]>
---
v2: The v1 patch has been accpeted in wireless patchwork. However,
this patch is very important for existing system, we need to add
cc stable tag and hope this patch can be pulled to stable branch earlier.
---
drivers/net/wireless/mediatek/mt76/mt7921/dma.c | 4 ----
drivers/net/wireless/mediatek/mt76/mt7921/mcu.c | 8 --------
drivers/net/wireless/mediatek/mt76/mt7921/pci.c | 8 ++++++++
3 files changed, 8 insertions(+), 12 deletions(-)
diff --git a/drivers/net/wireless/mediatek/mt76/mt7921/dma.c b/drivers/net/wireless/mediatek/mt76/mt7921/dma.c
index f0a80c2b476a..4153cd6c2a01 100644
--- a/drivers/net/wireless/mediatek/mt76/mt7921/dma.c
+++ b/drivers/net/wireless/mediatek/mt76/mt7921/dma.c
@@ -231,10 +231,6 @@ int mt7921_dma_init(struct mt7921_dev *dev)
if (ret)
return ret;
- ret = mt7921_wfsys_reset(dev);
- if (ret)
- return ret;
-
/* init tx queue */
ret = mt76_connac_init_tx_queues(dev->phy.mt76, MT7921_TXQ_BAND0,
MT7921_TX_RING_SIZE,
diff --git a/drivers/net/wireless/mediatek/mt76/mt7921/mcu.c b/drivers/net/wireless/mediatek/mt76/mt7921/mcu.c
index c69ce6df4956..f55caa00ac69 100644
--- a/drivers/net/wireless/mediatek/mt76/mt7921/mcu.c
+++ b/drivers/net/wireless/mediatek/mt76/mt7921/mcu.c
@@ -476,12 +476,6 @@ static int mt7921_load_firmware(struct mt7921_dev *dev)
{
int ret;
- ret = mt76_get_field(dev, MT_CONN_ON_MISC, MT_TOP_MISC2_FW_N9_RDY);
- if (ret && mt76_is_mmio(&dev->mt76)) {
- dev_dbg(dev->mt76.dev, "Firmware is already download\n");
- goto fw_loaded;
- }
-
ret = mt76_connac2_load_patch(&dev->mt76, mt7921_patch_name(dev));
if (ret)
return ret;
@@ -504,8 +498,6 @@ static int mt7921_load_firmware(struct mt7921_dev *dev)
return -EIO;
}
-fw_loaded:
-
#ifdef CONFIG_PM
dev->mt76.hw->wiphy->wowlan = &mt76_connac_wowlan_support;
#endif /* CONFIG_PM */
diff --git a/drivers/net/wireless/mediatek/mt76/mt7921/pci.c b/drivers/net/wireless/mediatek/mt76/mt7921/pci.c
index 1c727870bbdb..6c512bc75685 100644
--- a/drivers/net/wireless/mediatek/mt76/mt7921/pci.c
+++ b/drivers/net/wireless/mediatek/mt76/mt7921/pci.c
@@ -325,6 +325,10 @@ static int mt7921_pci_probe(struct pci_dev *pdev,
bus_ops->rmw = mt7921_rmw;
dev->mt76.bus = bus_ops;
+ ret = mt7921e_mcu_fw_pmctrl(dev);
+ if (ret)
+ goto err_free_dev;
+
ret = __mt7921e_mcu_drv_pmctrl(dev);
if (ret)
goto err_free_dev;
@@ -333,6 +337,10 @@ static int mt7921_pci_probe(struct pci_dev *pdev,
(mt7921_l1_rr(dev, MT_HW_REV) & 0xff);
dev_info(mdev->dev, "ASIC revision: %04x\n", mdev->rev);
+ ret = mt7921_wfsys_reset(dev);
+ if (ret)
+ goto err_free_dev;
+
mt76_wr(dev, MT_WFDMA0_HOST_INT_ENA, 0);
mt76_wr(dev, MT_PCIE_MAC_INT_ENABLE, 0xff);
--
2.18.0
Hello:
This patch was applied to netdev/net.git (main)
by Jakub Kicinski <[email protected]>:
On Wed, 5 Jul 2023 23:26:38 +0800 you wrote:
> From: Quan Zhou <[email protected]>
>
> For some cases as below, we may encounter the unpreditable chip stats
> in driver probe()
> * The system reboot flow do not work properly, such as kernel oops while
> rebooting, and then the driver do not go back to default status at
> this moment.
> * Similar to the flow above. If the device was enabled in BIOS or UEFI,
> the system may switch to Linux without driver fully shutdown.
>
> [...]
Here is the summary with links:
- [v2] wifi: mt76: mt7921e: fix init command fail with enabled device
https://git.kernel.org/netdev/net/c/525c469e5de9
You are awesome, thank you!
--
Deet-doot-dot, I am a bot.
https://korg.docs.kernel.org/patchwork/pwbot.html