When running in AP mode, the driver reports all deletions from CAM in
a cryptic manner that makes users think it is an error. change so that
the condition is only reported at higher-levels of debugging.
Signed-off-by: Larry Finger <[email protected]>
---
John,
This is 3.6 material.
Larry
---
Index: wireless-testing/drivers/net/wireless/rtlwifi/cam.c
===================================================================
--- wireless-testing.orig/drivers/net/wireless/rtlwifi/cam.c
+++ wireless-testing/drivers/net/wireless/rtlwifi/cam.c
@@ -128,7 +128,7 @@ u8 rtl_cam_add_one_entry(struct ieee8021
u32 us_config;
struct rtl_priv *rtlpriv = rtl_priv(hw);
- RT_TRACE(rtlpriv, COMP_SEC, DBG_DMESG,
+ RT_TRACE(rtlpriv, COMP_SEC, DBG_LOUD,
"EntryNo:%x, ulKeyId=%x, ulEncAlg=%x, ulUseDK=%x MacAddr %pM\n",
ul_entry_idx, ul_key_id, ul_enc_alg,
ul_default_key, mac_addr);
@@ -342,7 +342,8 @@ void rtl_cam_del_entry(struct ieee80211_
/* Remove from HW Security CAM */
memset(rtlpriv->sec.hwsec_cam_sta_addr[i], 0, ETH_ALEN);
rtlpriv->sec.hwsec_cam_bitmap &= ~(BIT(0) << i);
- pr_info("&&&&&&&&&del entry %d\n", i);
+ RT_TRACE(rtlpriv, COMP_SEC, DBG_LOUD,
+ "del CAM entry %d\n", i);
}
}
return;