From: Philipp Rossak <[email protected]>
There is no need for pincontrol nodes when the pin is set to a GPIO
Signed-off-by: Philipp Rossak <[email protected]>
---
This is Patch is a new version of the following patch:
https://patchwork.kernel.org/patch/9934835/
changes since version 1:
* vqmmc-supply was added again
* The pincontrolers for the leds and gpio_keys were removed
arch/arm/boot/dts/sun8i-h3-bananapi-m2-plus.dts | 20 --------------------
1 file changed, 20 deletions(-)
diff --git a/arch/arm/boot/dts/sun8i-h3-bananapi-m2-plus.dts b/arch/arm/boot/dts/sun8i-h3-bananapi-m2-plus.dts
index d756ff8..cc20d67 100644
--- a/arch/arm/boot/dts/sun8i-h3-bananapi-m2-plus.dts
+++ b/arch/arm/boot/dts/sun8i-h3-bananapi-m2-plus.dts
@@ -64,7 +64,6 @@
leds {
compatible = "gpio-leds";
pinctrl-names = "default";
- pinctrl-0 = <&pwr_led_bpi_m2p>;
pwr_led {
label = "bananapi-m2-plus:red:pwr";
@@ -76,7 +75,6 @@
gpio_keys {
compatible = "gpio-keys";
pinctrl-names = "default";
- pinctrl-0 = <&sw_r_bpi_m2p>;
sw4 {
label = "power";
@@ -98,7 +96,6 @@
wifi_pwrseq: wifi_pwrseq {
compatible = "mmc-pwrseq-simple";
pinctrl-names = "default";
- pinctrl-0 = <&wifi_en_bpi_m2p>;
reset-gpios = <&r_pio 0 7 GPIO_ACTIVE_LOW>; /* PL7 */
};
};
@@ -190,23 +187,6 @@
status = "okay";
};
-&r_pio {
- pwr_led_bpi_m2p: led_pins@0 {
- pins = "PL10";
- function = "gpio_out";
- };
-
- sw_r_bpi_m2p: key_pins@0 {
- pins = "PL3";
- function = "gpio_in";
- };
-
- wifi_en_bpi_m2p: wifi_en_pin {
- pins = "PL7";
- function = "gpio_out";
- };
-};
-
®_usb0_vbus {
gpio = <&pio 3 11 GPIO_ACTIVE_HIGH>; /* PD11 */
status = "okay";
--
2.7.4
On Tue, Sep 05, 2017 at 10:34:16PM +0200, Philipp Rossak wrote:
> From: Philipp Rossak <[email protected]>
>
> There is no need for pincontrol nodes when the pin is set to a GPIO
>
> Signed-off-by: Philipp Rossak <[email protected]>
Applied, thanks!
Maxime
--
Maxime Ripard, Free Electrons
Embedded Linux and Kernel engineering
http://free-electrons.com