This change will convert nandc to chip in Read/Write helper, this
change is needed because if we wnated to access number of steps
in Read/Write helper then we need to get the chip->ecc.steps,
currentlly its not possible.After this change we can directly
acces chip->ecc.steps in Read/Write helper.
Signed-off-by: Md Sadre Alam <[email protected]>
---
drivers/mtd/nand/raw/qcom_nandc.c | 52 +++++++++++++++++++++++----------------
1 file changed, 31 insertions(+), 21 deletions(-)
diff --git a/drivers/mtd/nand/raw/qcom_nandc.c b/drivers/mtd/nand/raw/qcom_nandc.c
index 667e4bf..ae8870ec 100644
--- a/drivers/mtd/nand/raw/qcom_nandc.c
+++ b/drivers/mtd/nand/raw/qcom_nandc.c
@@ -1079,8 +1079,10 @@ static int write_data_dma(struct qcom_nand_controller *nandc, int reg_off,
* Helper to prepare DMA descriptors for configuring registers
* before reading a NAND page.
*/
-static void config_nand_page_read(struct qcom_nand_controller *nandc)
+static void config_nand_page_read(struct nand_chip *chip)
{
+ struct qcom_nand_controller *nandc = get_qcom_nand_controller(chip);
+
write_reg_dma(nandc, NAND_ADDR0, 2, 0);
write_reg_dma(nandc, NAND_DEV0_CFG0, 3, 0);
write_reg_dma(nandc, NAND_EBI2_ECC_BUF_CFG, 1, 0);
@@ -1094,8 +1096,10 @@ static void config_nand_page_read(struct qcom_nand_controller *nandc)
* before reading each codeword in NAND page.
*/
static void
-config_nand_cw_read(struct qcom_nand_controller *nandc, bool use_ecc)
+config_nand_cw_read(struct nand_chip *chip, bool use_ecc)
{
+ struct qcom_nand_controller *nandc = get_qcom_nand_controller(chip);
+
if (nandc->props->is_bam)
write_reg_dma(nandc, NAND_READ_LOCATION_0, 4,
NAND_BAM_NEXT_SGL);
@@ -1117,19 +1121,23 @@ config_nand_cw_read(struct qcom_nand_controller *nandc, bool use_ecc)
* single codeword in page
*/
static void
-config_nand_single_cw_page_read(struct qcom_nand_controller *nandc,
+config_nand_single_cw_page_read(struct nand_chip *chip,
bool use_ecc)
{
- config_nand_page_read(nandc);
- config_nand_cw_read(nandc, use_ecc);
+ struct qcom_nand_controller *nandc = get_qcom_nand_controller(chip);
+
+ config_nand_page_read(chip);
+ config_nand_cw_read(chip, use_ecc);
}
/*
* Helper to prepare DMA descriptors used to configure registers needed for
* before writing a NAND page.
*/
-static void config_nand_page_write(struct qcom_nand_controller *nandc)
+static void config_nand_page_write(struct nand_chip *chip)
{
+ struct qcom_nand_controller *nandc = get_qcom_nand_controller(chip);
+
write_reg_dma(nandc, NAND_ADDR0, 2, 0);
write_reg_dma(nandc, NAND_DEV0_CFG0, 3, 0);
write_reg_dma(nandc, NAND_EBI2_ECC_BUF_CFG, 1,
@@ -1140,8 +1148,10 @@ static void config_nand_page_write(struct qcom_nand_controller *nandc)
* Helper to prepare DMA descriptors for configuring registers
* before writing each codeword in NAND page.
*/
-static void config_nand_cw_write(struct qcom_nand_controller *nandc)
+static void config_nand_cw_write(struct nand_chip *chip)
{
+ struct qcom_nand_controller *nandc = get_qcom_nand_controller(chip);
+
write_reg_dma(nandc, NAND_FLASH_CMD, 1, NAND_BAM_NEXT_SGL);
write_reg_dma(nandc, NAND_EXEC_CMD, 1, NAND_BAM_NEXT_SGL);
@@ -1215,7 +1225,7 @@ static int nandc_param(struct qcom_nand_host *host)
nandc->buf_count = 512;
memset(nandc->data_buffer, 0xff, nandc->buf_count);
- config_nand_single_cw_page_read(nandc, false);
+ config_nand_single_cw_page_read(chip, false);
read_data_dma(nandc, FLASH_BUF_ACC, nandc->data_buffer,
nandc->buf_count, 0);
@@ -1617,7 +1627,7 @@ qcom_nandc_read_cw_raw(struct mtd_info *mtd, struct nand_chip *chip,
clear_bam_transaction(nandc);
set_address(host, host->cw_size * cw, page);
update_rw_regs(host, 1, true);
- config_nand_page_read(nandc);
+ config_nand_page_read(chip);
data_size1 = mtd->writesize - host->cw_size * (ecc->steps - 1);
oob_size1 = host->bbm_size;
@@ -1645,7 +1655,7 @@ qcom_nandc_read_cw_raw(struct mtd_info *mtd, struct nand_chip *chip,
nandc_set_read_loc(nandc, 3, read_loc, oob_size2, 1);
}
- config_nand_cw_read(nandc, false);
+ config_nand_cw_read(chip, false);
read_data_dma(nandc, reg_off, data_buf, data_size1, 0);
reg_off += data_size1;
@@ -1856,7 +1866,7 @@ static int read_page_ecc(struct qcom_nand_host *host, u8 *data_buf,
u8 *data_buf_start = data_buf, *oob_buf_start = oob_buf;
int i, ret;
- config_nand_page_read(nandc);
+ config_nand_page_read(chip);
/* queue cmd descs for each codeword */
for (i = 0; i < ecc->steps; i++) {
@@ -1884,7 +1894,7 @@ static int read_page_ecc(struct qcom_nand_host *host, u8 *data_buf,
}
}
- config_nand_cw_read(nandc, true);
+ config_nand_cw_read(chip, true);
if (data_buf)
read_data_dma(nandc, FLASH_BUF_ACC, data_buf,
@@ -1946,7 +1956,7 @@ static int copy_last_cw(struct qcom_nand_host *host, int page)
set_address(host, host->cw_size * (ecc->steps - 1), page);
update_rw_regs(host, 1, true);
- config_nand_single_cw_page_read(nandc, host->use_ecc);
+ config_nand_single_cw_page_read(chip, host->use_ecc);
read_data_dma(nandc, FLASH_BUF_ACC, nandc->data_buffer, size, 0);
@@ -2036,7 +2046,7 @@ static int qcom_nandc_write_page(struct nand_chip *chip, const uint8_t *buf,
host->use_ecc = true;
update_rw_regs(host, ecc->steps, false);
- config_nand_page_write(nandc);
+ config_nand_page_write(chip);
for (i = 0; i < ecc->steps; i++) {
int data_size, oob_size;
@@ -2068,7 +2078,7 @@ static int qcom_nandc_write_page(struct nand_chip *chip, const uint8_t *buf,
oob_buf, oob_size, 0);
}
- config_nand_cw_write(nandc);
+ config_nand_cw_write(chip);
data_buf += data_size;
oob_buf += oob_size;
@@ -2107,7 +2117,7 @@ static int qcom_nandc_write_page_raw(struct nand_chip *chip,
host->use_ecc = false;
update_rw_regs(host, ecc->steps, false);
- config_nand_page_write(nandc);
+ config_nand_page_write(chip);
for (i = 0; i < ecc->steps; i++) {
int data_size1, data_size2, oob_size1, oob_size2;
@@ -2144,7 +2154,7 @@ static int qcom_nandc_write_page_raw(struct nand_chip *chip,
write_data_dma(nandc, reg_off, oob_buf, oob_size2, 0);
oob_buf += oob_size2;
- config_nand_cw_write(nandc);
+ config_nand_cw_write(chip);
}
ret = submit_descs(nandc);
@@ -2191,10 +2201,10 @@ static int qcom_nandc_write_oob(struct nand_chip *chip, int page)
set_address(host, host->cw_size * (ecc->steps - 1), page);
update_rw_regs(host, 1, false);
- config_nand_page_write(nandc);
+ config_nand_page_write(chip);
write_data_dma(nandc, FLASH_BUF_ACC,
nandc->data_buffer, data_size + oob_size, 0);
- config_nand_cw_write(nandc);
+ config_nand_cw_write(chip);
ret = submit_descs(nandc);
@@ -2270,10 +2280,10 @@ static int qcom_nandc_block_markbad(struct nand_chip *chip, loff_t ofs)
set_address(host, host->cw_size * (ecc->steps - 1), page);
update_rw_regs(host, 1, false);
- config_nand_page_write(nandc);
+ config_nand_page_write(chip);
write_data_dma(nandc, FLASH_BUF_ACC,
nandc->data_buffer, host->cw_size, 0);
- config_nand_cw_write(nandc);
+ config_nand_cw_write(chip);
ret = submit_descs(nandc);
--
2.7.4
Hello,
Md Sadre Alam <[email protected]> wrote on Mon, 22 Feb 2021
01:55:01 +0530:
> This change will convert nandc to chip in Read/Write helper, this
> change is needed because if we wnated to access number of steps
> in Read/Write helper then we need to get the chip->ecc.steps,
> currentlly its not possible.After this change we can directly
> acces chip->ecc.steps in Read/Write helper.
>
> Signed-off-by: Md Sadre Alam <[email protected]>
Thanks for splitting your series, I think it's much easier to review
and contains much less imprecise changes.
I have a few minor comments (see the following e-mails), please address
them and then please send all your patches a single series, not like 6+
independent patches.
I'll then require someone to test it if we are good I'll merge it.
Thanks,
Miquèl