-stable review patch. If anyone has any objections, please let us know.
---------------------
From: Michael Buesch <[email protected]>
This is a backport of upstream commit 013978b6 ("b43: Changes to enable
BCM4311 rev 02 with wireless core revision 13") and the changes include
the following:
(1) Add the 802.11 rev 13 device to the ssb_device_id table to load b43.
(2) Add PHY revision 9 to the supported list.
(3) Change the 2-bit routing code for address extensions to 0b10 rather
than the 0b01 used for the 32-bit case.
(4) Remove some magic numbers in the DMA setup.
The DMA implementation for this chip supports full 64-bit addressing with
one exception. Whenever the Descriptor Ring Buffer is in high memory, a
fatal DMA error occurs. This problem was not present in 2.6.24-rc2 due
to code to "Bias the placement of kernel pages at lower PFNs". When
commit 44048d70 reverted that code, the DMA error appeared. As a "fix",
use the GFP_DMA flag when allocating the buffer for 64-bit DMA. At present,
this problem is thought to arise from a hardware error.
Signed-off-by: Michael Buesch <[email protected]>
Cc: Larry Finger <[email protected]>
Cc: John W. Linville <[email protected]>
Cc: Alexey Zaytsev <[email protected]>
Signed-off-by: Chris Wright <[email protected]>
Signed-off-by: Greg Kroah-Hartman <[email protected]>
---
drivers/net/wireless/b43/dma.c | 30 ++++++++++++++++++++++--------
drivers/net/wireless/b43/main.c | 3 ++-
2 files changed, 24 insertions(+), 9 deletions(-)
--- a/drivers/net/wireless/b43/dma.c
+++ b/drivers/net/wireless/b43/dma.c
@@ -165,7 +165,7 @@ static void op64_fill_descriptor(struct
addrhi = (((u64) dmaaddr >> 32) & ~SSB_DMA_TRANSLATION_MASK);
addrext = (((u64) dmaaddr >> 32) & SSB_DMA_TRANSLATION_MASK)
>> SSB_DMA_TRANSLATION_SHIFT;
- addrhi |= ssb_dma_translation(ring->dev->dev);
+ addrhi |= (ssb_dma_translation(ring->dev->dev) << 1);
if (slot == ring->nr_slots - 1)
ctl0 |= B43_DMA64_DCTL0_DTABLEEND;
if (start)
@@ -426,9 +426,21 @@ static inline
static int alloc_ringmemory(struct b43_dmaring *ring)
{
struct device *dev = ring->dev->dev->dev;
+ gfp_t flags = GFP_KERNEL;
+ /* The specs call for 4K buffers for 30- and 32-bit DMA with 4K
+ * alignment and 8K buffers for 64-bit DMA with 8K alignment. Testing
+ * has shown that 4K is sufficient for the latter as long as the buffer
+ * does not cross an 8K boundary.
+ *
+ * For unknown reasons - possibly a hardware error - the BCM4311 rev
+ * 02, which uses 64-bit DMA, needs the ring buffer in very low memory,
+ * which accounts for the GFP_DMA flag below.
+ */
+ if (ring->dma64)
+ flags |= GFP_DMA;
ring->descbase = dma_alloc_coherent(dev, B43_DMA_RINGMEMSIZE,
- &(ring->dmabase), GFP_KERNEL);
+ &(ring->dmabase), flags);
if (!ring->descbase) {
b43err(ring->dev->wl, "DMA ringmemory allocation failed\n");
return -ENOMEM;
@@ -483,7 +495,7 @@ int b43_dmacontroller_rx_reset(struct b4
return 0;
}
-/* Reset the RX DMA channel */
+/* Reset the TX DMA channel */
int b43_dmacontroller_tx_reset(struct b43_wldev *dev, u16 mmio_base, int dma64)
{
int i;
@@ -647,7 +659,7 @@ static int dmacontroller_setup(struct b4
b43_dma_write(ring, B43_DMA64_TXRINGHI,
((ringbase >> 32) &
~SSB_DMA_TRANSLATION_MASK)
- | trans);
+ | (trans << 1));
} else {
u32 ringbase = (u32) (ring->dmabase);
@@ -680,8 +692,9 @@ static int dmacontroller_setup(struct b4
b43_dma_write(ring, B43_DMA64_RXRINGHI,
((ringbase >> 32) &
~SSB_DMA_TRANSLATION_MASK)
- | trans);
- b43_dma_write(ring, B43_DMA64_RXINDEX, 200);
+ | (trans << 1));
+ b43_dma_write(ring, B43_DMA64_RXINDEX, ring->nr_slots *
+ sizeof(struct b43_dmadesc64));
} else {
u32 ringbase = (u32) (ring->dmabase);
@@ -695,11 +708,12 @@ static int dmacontroller_setup(struct b4
b43_dma_write(ring, B43_DMA32_RXRING,
(ringbase & ~SSB_DMA_TRANSLATION_MASK)
| trans);
- b43_dma_write(ring, B43_DMA32_RXINDEX, 200);
+ b43_dma_write(ring, B43_DMA32_RXINDEX, ring->nr_slots *
+ sizeof(struct b43_dmadesc32));
}
}
- out:
+out:
return err;
}
--- a/drivers/net/wireless/b43/main.c
+++ b/drivers/net/wireless/b43/main.c
@@ -101,6 +101,7 @@ static const struct ssb_device_id b43_ss
SSB_DEVICE(SSB_VENDOR_BROADCOM, SSB_DEV_80211, 7),
SSB_DEVICE(SSB_VENDOR_BROADCOM, SSB_DEV_80211, 9),
SSB_DEVICE(SSB_VENDOR_BROADCOM, SSB_DEV_80211, 10),
+ SSB_DEVICE(SSB_VENDOR_BROADCOM, SSB_DEV_80211, 13),
SSB_DEVTABLE_END
};
@@ -3079,7 +3080,7 @@ static int b43_phy_versioning(struct b43
unsupported = 1;
break;
case B43_PHYTYPE_G:
- if (phy_rev > 8)
+ if (phy_rev > 9)
unsupported = 1;
break;
default:
--