Convert printks to use dev_printk().
Signed-off-by: Bjorn Helgaas <[email protected]>
---
drivers/pci/pcie/aer/aerdrv.c | 8 +++-----
drivers/pci/pcie/aer/aerdrv_acpi.c | 8 ++++----
drivers/pci/pcie/aer/aerdrv_core.c | 24 ++++++++++++------------
3 files changed, 19 insertions(+), 21 deletions(-)
Index: work11/drivers/pci/pcie/aer/aerdrv.c
===================================================================
--- work11.orig/drivers/pci/pcie/aer/aerdrv.c 2008-06-26 12:27:39.000000000 -0600
+++ work11/drivers/pci/pcie/aer/aerdrv.c 2008-06-26 12:30:14.000000000 -0600
@@ -219,8 +219,7 @@ static int __devinit aer_probe (struct p
/* Alloc rpc data structure */
if (!(rpc = aer_alloc_rpc(dev))) {
- printk(KERN_DEBUG "%s: Alloc rpc fails on PCIE device[%s]\n",
- __func__, device->bus_id);
+ dev_printk(KERN_DEBUG, device, "alloc rpc failed\n");
aer_remove(dev);
return -ENOMEM;
}
@@ -228,8 +227,7 @@ static int __devinit aer_probe (struct p
/* Request IRQ ISR */
if ((status = request_irq(dev->irq, aer_irq, IRQF_SHARED, "aerdrv",
dev))) {
- printk(KERN_DEBUG "%s: Request ISR fails on PCIE device[%s]\n",
- __func__, device->bus_id);
+ dev_printk(KERN_DEBUG, device, "request IRQ failed\n");
aer_remove(dev);
return status;
}
@@ -273,7 +271,7 @@ static pci_ers_result_t aer_root_reset(s
* to issue Configuration Requests to those devices.
*/
msleep(200);
- printk(KERN_DEBUG "Complete link reset at Root[%s]\n", dev->dev.bus_id);
+ dev_printk(KERN_DEBUG, &dev->dev, "Root Port link has been reset\n");
/* Enable Root Port's interrupt in response to error messages */
pci_read_config_dword(dev, pos + PCI_ERR_ROOT_STATUS, &status);
Index: work11/drivers/pci/pcie/aer/aerdrv_acpi.c
===================================================================
--- work11.orig/drivers/pci/pcie/aer/aerdrv_acpi.c 2008-06-26 12:27:39.000000000 -0600
+++ work11/drivers/pci/pcie/aer/aerdrv_acpi.c 2008-06-26 12:30:14.000000000 -0600
@@ -50,10 +50,10 @@ int aer_osc_setup(struct pcie_device *pc
}
if (ACPI_FAILURE(status)) {
- printk(KERN_DEBUG "AER service couldn't init device %s - %s\n",
- pciedev->device.bus_id,
- (status == AE_SUPPORT || status == AE_NOT_FOUND) ?
- "no _OSC support" : "Run ACPI _OSC fails");
+ dev_printk(KERN_DEBUG, &pciedev->device, "AER service couldn't "
+ "init device: %s\n",
+ (status == AE_SUPPORT || status == AE_NOT_FOUND) ?
+ "no _OSC support" : "_OSC failed");
return -1;
}
Index: work11/drivers/pci/pcie/aer/aerdrv_core.c
===================================================================
--- work11.orig/drivers/pci/pcie/aer/aerdrv_core.c 2008-06-26 12:27:39.000000000 -0600
+++ work11/drivers/pci/pcie/aer/aerdrv_core.c 2008-06-26 12:30:14.000000000 -0600
@@ -221,9 +221,9 @@ static void report_error_detected(struct
* of a driver for this device is unaware of
* its hw state.
*/
- printk(KERN_DEBUG "Device ID[%s] has %s\n",
- dev->dev.bus_id, (dev->driver) ?
- "no AER-aware driver" : "no driver");
+ dev_printk(KERN_DEBUG, &dev->dev, "device has %s\n",
+ dev->driver ?
+ "no AER-aware driver" : "no driver");
}
return;
}
@@ -304,7 +304,7 @@ static pci_ers_result_t broadcast_error_
{
struct aer_broadcast_data result_data;
- printk(KERN_DEBUG "Broadcast %s message\n", error_mesg);
+ dev_printk(KERN_DEBUG, &dev->dev, "broadcast %s message\n", error_mesg);
result_data.state = state;
if (cb == report_error_detected)
result_data.result = PCI_ERS_RESULT_CAN_RECOVER;
@@ -404,18 +404,16 @@ static pci_ers_result_t reset_link(struc
data.aer_driver =
to_service_driver(aerdev->device.driver);
} else {
- printk(KERN_DEBUG "No link-reset support to Device ID"
- "[%s]\n",
- dev->dev.bus_id);
+ dev_printk(KERN_DEBUG, &dev->dev, "no link-reset "
+ "support\n");
return PCI_ERS_RESULT_DISCONNECT;
}
}
status = data.aer_driver->reset_link(udev);
if (status != PCI_ERS_RESULT_RECOVERED) {
- printk(KERN_DEBUG "Link reset at upstream Device ID"
- "[%s] failed\n",
- udev->dev.bus_id);
+ dev_printk(KERN_DEBUG, &dev->dev, "link reset at upstream "
+ "device %s failed\n", pci_name(udev));
return PCI_ERS_RESULT_DISCONNECT;
}
@@ -511,10 +509,12 @@ static void handle_error_source(struct p
} else {
status = do_recovery(aerdev, dev, info.severity);
if (status == PCI_ERS_RESULT_RECOVERED) {
- printk(KERN_DEBUG "AER driver successfully recovered\n");
+ dev_printk(KERN_DEBUG, &dev->dev, "AER driver "
+ "successfully recovered\n");
} else {
/* TODO: Should kernel panic here? */
- printk(KERN_DEBUG "AER driver didn't recover\n");
+ dev_printk(KERN_DEBUG, &dev->dev, "AER driver didn't "
+ "recover\n");
}
}
}
--