There's a potential race in xennet_remove(); this is what the driver is
doing upon unregistering a network device:
1. state = read bus state
2. if state is not "Closed":
3. request to set state to "Closing"
4. wait for state to be set to "Closing"
5. request to set state to "Closed"
6. wait for state to be set to "Closed"
If the state changes to "Closed" immediately after step 1 we are stuck
forever in step 4, because the state will never go back from "Closed" to
"Closing".
Make sure to check also for state == "Closed" in step 4 to prevent the
deadlock.
Also add a 5 sec timeout any time we wait for the bus state to change,
to avoid getting stuck forever in wait_event() and add a debug message
to help tracking down potential similar issues.
Signed-off-by: Andrea Righi <[email protected]>
---
drivers/net/xen-netfront.c | 79 +++++++++++++++++++++++++++-----------
1 file changed, 57 insertions(+), 22 deletions(-)
diff --git a/drivers/net/xen-netfront.c b/drivers/net/xen-netfront.c
index 482c6c8b0fb7..e09caba93dd9 100644
--- a/drivers/net/xen-netfront.c
+++ b/drivers/net/xen-netfront.c
@@ -63,6 +63,8 @@ module_param_named(max_queues, xennet_max_queues, uint, 0644);
MODULE_PARM_DESC(max_queues,
"Maximum number of queues per virtual interface");
+#define XENNET_TIMEOUT (5 * HZ)
+
static const struct ethtool_ops xennet_ethtool_ops;
struct netfront_cb {
@@ -1334,12 +1336,20 @@ static struct net_device *xennet_create_dev(struct xenbus_device *dev)
netif_carrier_off(netdev);
- xenbus_switch_state(dev, XenbusStateInitialising);
- wait_event(module_wq,
- xenbus_read_driver_state(dev->otherend) !=
- XenbusStateClosed &&
- xenbus_read_driver_state(dev->otherend) !=
- XenbusStateUnknown);
+ do {
+ dev_dbg(&dev->dev,
+ "%s: switching to XenbusStateInitialising\n",
+ dev->nodename);
+ xenbus_switch_state(dev, XenbusStateInitialising);
+ err = wait_event_timeout(module_wq,
+ xenbus_read_driver_state(dev->otherend) !=
+ XenbusStateClosed &&
+ xenbus_read_driver_state(dev->otherend) !=
+ XenbusStateUnknown, XENNET_TIMEOUT);
+ dev_dbg(&dev->dev, "%s: state = %d\n", dev->nodename,
+ xenbus_read_driver_state(dev->otherend));
+ } while (!err);
+
return netdev;
exit:
@@ -2139,28 +2149,53 @@ static const struct attribute_group xennet_dev_group = {
};
#endif /* CONFIG_SYSFS */
-static int xennet_remove(struct xenbus_device *dev)
+static void xennet_bus_close(struct xenbus_device *dev)
{
- struct netfront_info *info = dev_get_drvdata(&dev->dev);
-
- dev_dbg(&dev->dev, "%s\n", dev->nodename);
+ int ret;
- if (xenbus_read_driver_state(dev->otherend) != XenbusStateClosed) {
+ if (xenbus_read_driver_state(dev->otherend) == XenbusStateClosed)
+ return;
+ do {
+ dev_dbg(&dev->dev, "%s: switching to XenbusStateClosing\n",
+ dev->nodename);
xenbus_switch_state(dev, XenbusStateClosing);
- wait_event(module_wq,
- xenbus_read_driver_state(dev->otherend) ==
- XenbusStateClosing ||
- xenbus_read_driver_state(dev->otherend) ==
- XenbusStateUnknown);
+ ret = wait_event_timeout(module_wq,
+ xenbus_read_driver_state(dev->otherend) ==
+ XenbusStateClosing ||
+ xenbus_read_driver_state(dev->otherend) ==
+ XenbusStateClosed ||
+ xenbus_read_driver_state(dev->otherend) ==
+ XenbusStateUnknown,
+ XENNET_TIMEOUT);
+ dev_dbg(&dev->dev, "%s: state = %d\n", dev->nodename,
+ xenbus_read_driver_state(dev->otherend));
+ } while (!ret);
+
+ if (xenbus_read_driver_state(dev->otherend) == XenbusStateClosed)
+ return;
+ do {
+ dev_dbg(&dev->dev, "%s: switching to XenbusStateClosed\n",
+ dev->nodename);
xenbus_switch_state(dev, XenbusStateClosed);
- wait_event(module_wq,
- xenbus_read_driver_state(dev->otherend) ==
- XenbusStateClosed ||
- xenbus_read_driver_state(dev->otherend) ==
- XenbusStateUnknown);
- }
+ ret = wait_event_timeout(module_wq,
+ xenbus_read_driver_state(dev->otherend) ==
+ XenbusStateClosed ||
+ xenbus_read_driver_state(dev->otherend) ==
+ XenbusStateUnknown,
+ XENNET_TIMEOUT);
+ dev_dbg(&dev->dev, "%s: state = %d\n", dev->nodename,
+ xenbus_read_driver_state(dev->otherend));
+ } while (!ret);
+}
+
+static int xennet_remove(struct xenbus_device *dev)
+{
+ struct netfront_info *info = dev_get_drvdata(&dev->dev);
+
+ dev_dbg(&dev->dev, "%s\n", dev->nodename);
+ xennet_bus_close(dev);
xennet_disconnect_backend(info);
if (info->netdev->reg_state == NETREG_REGISTERED)
--
2.25.1
From: Andrea Righi <[email protected]>
Date: Wed, 22 Jul 2020 08:52:11 +0200
> +static int xennet_remove(struct xenbus_device *dev)
> +{
> + struct netfront_info *info = dev_get_drvdata(&dev->dev);
> +
> + dev_dbg(&dev->dev, "%s\n", dev->nodename);
These kinds of debugging messages provide zero context and are so much
less useful than simply using tracepoints which are more universally
available than printk debugging facilities.
Please remove all of the dev_dbg() calls from this patch.
On Thu, Jul 23, 2020 at 02:57:22PM -0700, David Miller wrote:
> From: Andrea Righi <[email protected]>
> Date: Wed, 22 Jul 2020 08:52:11 +0200
>
> > +static int xennet_remove(struct xenbus_device *dev)
> > +{
> > + struct netfront_info *info = dev_get_drvdata(&dev->dev);
> > +
> > + dev_dbg(&dev->dev, "%s\n", dev->nodename);
>
> These kinds of debugging messages provide zero context and are so much
> less useful than simply using tracepoints which are more universally
> available than printk debugging facilities.
>
> Please remove all of the dev_dbg() calls from this patch.
I didn't add that dev_dbg() call, it's just the old code moved around,
but I agree, I'll remove that call and send a new version of this patch.
Thanks for looking at it!
-Andrea