From: Niklas Cassel <[email protected]>
The write pointer in NVMe ZNS is invalid for a zone in zone state full.
The same also holds true for ZAC/ZBC.
The current behavior for NVMe is to simply propagate the wp reported by
the drive, even for full zones. Since the wp is invalid for a full zone,
the wp reported by the drive might be implemented as a don't care term.
The way that the sd_zbc driver handles a full zone is to always report
the wp as zone start + zone len, regardless of what the drive reported.
null_blk also follows this convention.
Do the same for NVMe, so that a BLKREPORTZONE ioctl reports the write
pointer for a full zone in a consistent way, regardless of the interface
of the underlying zoned block device.
blkzone report before patch:
start: 0x000040000, len 0x040000, cap 0x03e000, wptr 0xfffffffffffbfff8
reset:0 non-seq:0, zcond:14(fu) [type: 2(SEQ_WRITE_REQUIRED)]
blkzone report after patch:
start: 0x000040000, len 0x040000, cap 0x03e000, wptr 0x040000 reset:0
non-seq:0, zcond:14(fu) [type: 2(SEQ_WRITE_REQUIRED)]
Signed-off-by: Niklas Cassel <[email protected]>
---
drivers/nvme/host/zns.c | 2 ++
1 file changed, 2 insertions(+)
diff --git a/drivers/nvme/host/zns.c b/drivers/nvme/host/zns.c
index bfc259e0d7b8..4091b955ce62 100644
--- a/drivers/nvme/host/zns.c
+++ b/drivers/nvme/host/zns.c
@@ -167,6 +167,8 @@ static int nvme_zone_parse_entry(struct nvme_ns *ns,
zone.capacity = nvme_lba_to_sect(ns, le64_to_cpu(entry->zcap));
zone.start = nvme_lba_to_sect(ns, le64_to_cpu(entry->zslba));
zone.wp = nvme_lba_to_sect(ns, le64_to_cpu(entry->wp));
+ if (zone.cond == BLK_ZONE_COND_FULL)
+ zone.wp = zone.start + zone.len;
return cb(&zone, idx, data);
}
--
2.33.1