The Northwest Logic MIPI DSI host controller embedded in i.MX8qxp
works with a Mixel MIPI DPHY + LVDS PHY combo to support either
a MIPI DSI display or a LVDS display. So, this patch calls
phy_set_mode() from nwl_dsi_mode_set() to set PHY mode to MIPI DPHY
explicitly.
Cc: Guido Günther <[email protected]>
Cc: Robert Chiras <[email protected]>
Cc: Martin Kepplinger <[email protected]>
Cc: Andrzej Hajda <[email protected]>
Cc: Neil Armstrong <[email protected]>
Cc: Laurent Pinchart <[email protected]>
Cc: Jonas Karlman <[email protected]>
Cc: Jernej Skrabec <[email protected]>
Cc: David Airlie <[email protected]>
Cc: Daniel Vetter <[email protected]>
Cc: NXP Linux Team <[email protected]>
Signed-off-by: Liu Ying <[email protected]>
---
v5->v6:
* Rebase the series upon v5.17-rc1.
* Set PHY mode in ->mode_set() instead of ->pre_enable() in the nwl-dsi
bridge driver due to the rebase.
* Drop Guido's R-b tag due to the rebase.
v4->v5:
* No change.
v3->v4:
* No change.
v2->v3:
* No change.
v1->v2:
* Add Guido's R-b tag.
drivers/gpu/drm/bridge/nwl-dsi.c | 6 ++++++
1 file changed, 6 insertions(+)
diff --git a/drivers/gpu/drm/bridge/nwl-dsi.c b/drivers/gpu/drm/bridge/nwl-dsi.c
index af07eeb47ca0..cbe3edb17ceb 100644
--- a/drivers/gpu/drm/bridge/nwl-dsi.c
+++ b/drivers/gpu/drm/bridge/nwl-dsi.c
@@ -671,6 +671,12 @@ static int nwl_dsi_mode_set(struct nwl_dsi *dsi)
return ret;
}
+ ret = phy_set_mode(dsi->phy, PHY_MODE_MIPI_DPHY);
+ if (ret < 0) {
+ DRM_DEV_ERROR(dev, "Failed to set DSI phy mode: %d\n", ret);
+ goto uninit_phy;
+ }
+
ret = phy_configure(dsi->phy, phy_cfg);
if (ret < 0) {
DRM_DEV_ERROR(dev, "Failed to configure DSI phy: %d\n", ret);
--
2.25.1