The setting of RS485 RTS polarity is inverse in the current driver.
When the property of 'rs485-rts-active-low' is enabled in the dts node,
the RTS signal should be LOW during sending. Otherwise, if there is no
such a property, the RTS should be HIGH during sending.
Fixes: 03895cf41d18 ("tty: serial: fsl_lpuart: Add support for RS-485")
Signed-off-by: Nicolas Diaz <[email protected]>
Signed-off-by: Shenwei Wang <[email protected]>
---
changes in v2:
- add the fix tag
drivers/tty/serial/fsl_lpuart.c | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/drivers/tty/serial/fsl_lpuart.c b/drivers/tty/serial/fsl_lpuart.c
index afa0f941c862..abc3a3674bc3 100644
--- a/drivers/tty/serial/fsl_lpuart.c
+++ b/drivers/tty/serial/fsl_lpuart.c
@@ -1394,9 +1394,9 @@ static int lpuart_config_rs485(struct uart_port *port, struct ktermios *termios,
* Note: UART is assumed to be active high.
*/
if (rs485->flags & SER_RS485_RTS_ON_SEND)
- modem &= ~UARTMODEM_TXRTSPOL;
- else if (rs485->flags & SER_RS485_RTS_AFTER_SEND)
modem |= UARTMODEM_TXRTSPOL;
+ else if (rs485->flags & SER_RS485_RTS_AFTER_SEND)
+ modem &= ~UARTMODEM_TXRTSPOL;
}
writeb(modem, sport->port.membase + UARTMODEM);
--
2.25.1