Defines prefixed with "CONFIG" should be limited to proper Kconfig options,
that are introduced in a Kconfig file.
Here, a definition for a bitmask to configure the SEND_ENABLE mode is named
CONFIG_SEND_ENABLE.
Rename this local definition to CONFIGURE_SEND_ENABLE to avoid defines
prefixed with "CONFIG".
No functional change.
Signed-off-by: Lukas Bulwahn <[email protected]>
---
drivers/pci/controller/pcie-rcar-host.c | 4 ++--
drivers/pci/controller/pcie-rcar.h | 2 +-
2 files changed, 3 insertions(+), 3 deletions(-)
diff --git a/drivers/pci/controller/pcie-rcar-host.c b/drivers/pci/controller/pcie-rcar-host.c
index e4faf90feaf5..52fdafe5c877 100644
--- a/drivers/pci/controller/pcie-rcar-host.c
+++ b/drivers/pci/controller/pcie-rcar-host.c
@@ -219,9 +219,9 @@ static int rcar_pcie_config_access(struct rcar_pcie_host *host,
/* Enable the configuration access */
if (pci_is_root_bus(bus->parent))
- rcar_pci_write_reg(pcie, CONFIG_SEND_ENABLE | TYPE0, PCIECCTLR);
+ rcar_pci_write_reg(pcie, CONFIGURE_SEND_ENABLE | TYPE0, PCIECCTLR);
else
- rcar_pci_write_reg(pcie, CONFIG_SEND_ENABLE | TYPE1, PCIECCTLR);
+ rcar_pci_write_reg(pcie, CONFIGURE_SEND_ENABLE | TYPE1, PCIECCTLR);
/* Check for errors */
if (rcar_pci_read_reg(pcie, PCIEERRFR) & UNSUPPORTED_REQUEST)
diff --git a/drivers/pci/controller/pcie-rcar.h b/drivers/pci/controller/pcie-rcar.h
index 9bb125db85c6..a09f58ab04ca 100644
--- a/drivers/pci/controller/pcie-rcar.h
+++ b/drivers/pci/controller/pcie-rcar.h
@@ -11,7 +11,7 @@
#define PCIECAR 0x000010
#define PCIECCTLR 0x000018
-#define CONFIG_SEND_ENABLE BIT(31)
+#define CONFIGURE_SEND_ENABLE BIT(31)
#define TYPE0 (0 << 8)
#define TYPE1 BIT(8)
#define PCIECDR 0x000020
--
2.17.1
Hi Lukas,
On Fri, Jan 13, 2023 at 9:52 AM Lukas Bulwahn <[email protected]> wrote:
> Defines prefixed with "CONFIG" should be limited to proper Kconfig options,
> that are introduced in a Kconfig file.
>
> Here, a definition for a bitmask to configure the SEND_ENABLE mode is named
> CONFIG_SEND_ENABLE.
>
> Rename this local definition to CONFIGURE_SEND_ENABLE to avoid defines
> prefixed with "CONFIG".
>
> No functional change.
>
> Signed-off-by: Lukas Bulwahn <[email protected]>
Thanks for your patch!
> --- a/drivers/pci/controller/pcie-rcar.h
> +++ b/drivers/pci/controller/pcie-rcar.h
> @@ -11,7 +11,7 @@
>
> #define PCIECAR 0x000010
> #define PCIECCTLR 0x000018
> -#define CONFIG_SEND_ENABLE BIT(31)
> +#define CONFIGURE_SEND_ENABLE BIT(31)
The R-Car Gen3 rev. 2.30 Hardware User's Manual calls the bit "CCIE".
Hence if I would have written the driver, I would have used
#define PCIECCTLR_CCIE BIT(31) /* Configuration Send Enable */
> #define TYPE0 (0 << 8)
> #define TYPE1 BIT(8)
> #define PCIECDR 0x000020
Gr{oetje,eeting}s,
Geert
--
Geert Uytterhoeven -- There's lots of Linux beyond ia32 -- [email protected]
In personal conversations with technical people, I call myself a hacker. But
when I'm talking to journalists I just say "programmer" or something like that.
-- Linus Torvalds
On Fri, Jan 13, 2023 at 10:05 AM Geert Uytterhoeven
<[email protected]> wrote:
> On Fri, Jan 13, 2023 at 9:52 AM Lukas Bulwahn <[email protected]> wrote:
> > Defines prefixed with "CONFIG" should be limited to proper Kconfig options,
> > that are introduced in a Kconfig file.
> >
> > Here, a definition for a bitmask to configure the SEND_ENABLE mode is named
> > CONFIG_SEND_ENABLE.
> >
> > Rename this local definition to CONFIGURE_SEND_ENABLE to avoid defines
> > prefixed with "CONFIG".
> >
> > No functional change.
> >
> > Signed-off-by: Lukas Bulwahn <[email protected]>
>
> Thanks for your patch!
>
> > --- a/drivers/pci/controller/pcie-rcar.h
> > +++ b/drivers/pci/controller/pcie-rcar.h
> > @@ -11,7 +11,7 @@
> >
> > #define PCIECAR 0x000010
> > #define PCIECCTLR 0x000018
> > -#define CONFIG_SEND_ENABLE BIT(31)
> > +#define CONFIGURE_SEND_ENABLE BIT(31)
>
> The R-Car Gen3 rev. 2.30 Hardware User's Manual calls the bit "CCIE".
>
> Hence if I would have written the driver, I would have used
>
> #define PCIECCTLR_CCIE BIT(31) /* Configuration Send Enable */
Regardless:
Reviewed-by: Geert Uytterhoeven <[email protected]>
Gr{oetje,eeting}s,
Geert
--
Geert Uytterhoeven -- There's lots of Linux beyond ia32 -- [email protected]
In personal conversations with technical people, I call myself a hacker. But
when I'm talking to journalists I just say "programmer" or something like that.
-- Linus Torvalds
Hi Lukas,
On Fri, Jan 13, 2023 at 09:45:16AM +0100, Lukas Bulwahn wrote:
> Defines prefixed with "CONFIG" should be limited to proper Kconfig options,
> that are introduced in a Kconfig file.
>
> Here, a definition for a bitmask to configure the SEND_ENABLE mode is named
> CONFIG_SEND_ENABLE.
>
> Rename this local definition to CONFIGURE_SEND_ENABLE to avoid defines
> prefixed with "CONFIG".
>
> No functional change.
If you update this patch, please capitalize the subject to match:
$ git log --oneline drivers/pci/controller/pcie-rcar-host.c
6e36203bc14c ("PCI: rcar: Use PCI_SET_ERROR_RESPONSE after read which triggered an exception")
84b576146294 ("PCI: rcar: Finish transition to L1 state in rcar_pcie_config_access()")
d2a14b54989e ("PCI: rcar: Check if device is runtime suspended instead of __clk_is_enabled()")
a115b1bd3af0 ("PCI: rcar: Add L1 link state fix into data abort hook")
83ed8d4fa656 ("PCI: rcar: Convert to MSI domains")
Bjorn
On Fri, Jan 13, 2023 at 10:05:09AM +0100, Geert Uytterhoeven wrote:
> Hi Lukas,
>
> On Fri, Jan 13, 2023 at 9:52 AM Lukas Bulwahn <[email protected]> wrote:
> > Defines prefixed with "CONFIG" should be limited to proper Kconfig options,
> > that are introduced in a Kconfig file.
> >
> > Here, a definition for a bitmask to configure the SEND_ENABLE mode is named
> > CONFIG_SEND_ENABLE.
> >
> > Rename this local definition to CONFIGURE_SEND_ENABLE to avoid defines
> > prefixed with "CONFIG".
> >
> > No functional change.
> >
> > Signed-off-by: Lukas Bulwahn <[email protected]>
>
> Thanks for your patch!
>
> > --- a/drivers/pci/controller/pcie-rcar.h
> > +++ b/drivers/pci/controller/pcie-rcar.h
> > @@ -11,7 +11,7 @@
> >
> > #define PCIECAR 0x000010
> > #define PCIECCTLR 0x000018
> > -#define CONFIG_SEND_ENABLE BIT(31)
> > +#define CONFIGURE_SEND_ENABLE BIT(31)
>
> The R-Car Gen3 rev. 2.30 Hardware User's Manual calls the bit "CCIE".
>
> Hence if I would have written the driver, I would have used
>
> #define PCIECCTLR_CCIE BIT(31) /* Configuration Send Enable */
Should I change it when I merge it ? That makes sense actually.
Thanks,
Lorenzo
> > #define TYPE0 (0 << 8)
> > #define TYPE1 BIT(8)
> > #define PCIECDR 0x000020
>
> Gr{oetje,eeting}s,
>
> Geert
>
> --
> Geert Uytterhoeven -- There's lots of Linux beyond ia32 -- [email protected]
>
> In personal conversations with technical people, I call myself a hacker. But
> when I'm talking to journalists I just say "programmer" or something like that.
> -- Linus Torvalds
On Fri, Jan 13, 2023 at 05:30:24PM +0100, Lorenzo Pieralisi wrote:
> On Fri, Jan 13, 2023 at 10:05:09AM +0100, Geert Uytterhoeven wrote:
> > Hi Lukas,
> >
> > On Fri, Jan 13, 2023 at 9:52 AM Lukas Bulwahn <[email protected]> wrote:
> > > Defines prefixed with "CONFIG" should be limited to proper Kconfig options,
> > > that are introduced in a Kconfig file.
> > >
> > > Here, a definition for a bitmask to configure the SEND_ENABLE mode is named
> > > CONFIG_SEND_ENABLE.
> > >
> > > Rename this local definition to CONFIGURE_SEND_ENABLE to avoid defines
> > > prefixed with "CONFIG".
> > >
> > > No functional change.
> > >
> > > Signed-off-by: Lukas Bulwahn <[email protected]>
> >
> > Thanks for your patch!
> >
> > > --- a/drivers/pci/controller/pcie-rcar.h
> > > +++ b/drivers/pci/controller/pcie-rcar.h
> > > @@ -11,7 +11,7 @@
> > >
> > > #define PCIECAR 0x000010
> > > #define PCIECCTLR 0x000018
> > > -#define CONFIG_SEND_ENABLE BIT(31)
> > > +#define CONFIGURE_SEND_ENABLE BIT(31)
> >
> > The R-Car Gen3 rev. 2.30 Hardware User's Manual calls the bit "CCIE".
> >
> > Hence if I would have written the driver, I would have used
> >
> > #define PCIECCTLR_CCIE BIT(31) /* Configuration Send Enable */
>
> Should I change it when I merge it ? That makes sense actually.
If I don't hear from anybody I will make the change above and merge it.
Thanks,
Lorenzo
>
> Thanks,
> Lorenzo
>
> > > #define TYPE0 (0 << 8)
> > > #define TYPE1 BIT(8)
> > > #define PCIECDR 0x000020
> >
> > Gr{oetje,eeting}s,
> >
> > Geert
> >
> > --
> > Geert Uytterhoeven -- There's lots of Linux beyond ia32 -- [email protected]
> >
> > In personal conversations with technical people, I call myself a hacker. But
> > when I'm talking to journalists I just say "programmer" or something like that.
> > -- Linus Torvalds
On Fri, 13 Jan 2023 09:45:16 +0100, Lukas Bulwahn wrote:
> Defines prefixed with "CONFIG" should be limited to proper Kconfig options,
> that are introduced in a Kconfig file.
>
> Here, a definition for a bitmask to configure the SEND_ENABLE mode is named
> CONFIG_SEND_ENABLE.
>
> Rename this local definition to CONFIGURE_SEND_ENABLE to avoid defines
> prefixed with "CONFIG".
>
> [...]
Applied to pci/rcar, thanks!
[1/1] PCI: rcar: avoid defines prefixed with CONFIG
https://git.kernel.org/pci/pci/c/727de4c08768
Thanks,
Lorenzo