From: Sinthu Raja <[email protected]>
AM68 Starter kit features with one PCIe M.2 Key M connector
interfaced via two SerDes lanes. Update the SerDes configuration
for PCIe.
Signed-off-by: Sinthu Raja <[email protected]>
Signed-off-by: Ravi Gunasekaran <[email protected]>
---
.../boot/dts/ti/k3-am68-sk-base-board.dts | 29 +++++++++++++++++++
1 file changed, 29 insertions(+)
diff --git a/arch/arm64/boot/dts/ti/k3-am68-sk-base-board.dts b/arch/arm64/boot/dts/ti/k3-am68-sk-base-board.dts
index 5df5946687b3..81c2307c77f9 100644
--- a/arch/arm64/boot/dts/ti/k3-am68-sk-base-board.dts
+++ b/arch/arm64/boot/dts/ti/k3-am68-sk-base-board.dts
@@ -553,3 +553,32 @@
};
};
};
+
+&serdes_ln_ctrl {
+ idle-states = <J721S2_SERDES0_LANE0_PCIE1_LANE0>, <J721S2_SERDES0_LANE1_PCIE1_LANE1>,
+ <J721S2_SERDES0_LANE2_USB_SWAP>, <J721S2_SERDES0_LANE3_USB>;
+};
+
+&serdes_refclk {
+ clock-frequency = <100000000>;
+};
+
+&serdes0 {
+ status = "okay";
+
+ serdes0_pcie_link: phy@0 {
+ reg = <0>;
+ cdns,num-lanes = <2>;
+ #phy-cells = <0>;
+ cdns,phy-type = <PHY_TYPE_PCIE>;
+ resets = <&serdes_wiz0 1>, <&serdes_wiz0 2>;
+ };
+};
+
+&pcie1_rc {
+ status = "okay";
+ reset-gpios = <&exp1 10 GPIO_ACTIVE_HIGH>;
+ phys = <&serdes0_pcie_link>;
+ phy-names = "pcie-phy";
+ num-lanes = <2>;
+};
--
2.17.1