Commit 7ed915059c3001 (gpio: raspberrypi-ext: fix firmware dependency)
fixed the Kconfig dependency to ensure that gpio-raspberrypi-exp is not
built-in when the firmware is a module. But the Kconfig syntax for doing
so is cryptic. Add a comment to make it a little easier.
Cc: Arnd Bergmann <[email protected]>
Signed-off-by: Baruch Siach <[email protected]>
---
drivers/gpio/Kconfig | 2 ++
1 file changed, 2 insertions(+)
diff --git a/drivers/gpio/Kconfig b/drivers/gpio/Kconfig
index 52a8b0a6f4e1..1bb25c1ff2d8 100644
--- a/drivers/gpio/Kconfig
+++ b/drivers/gpio/Kconfig
@@ -126,6 +126,8 @@ config GPIO_RASPBERRYPI_EXP
tristate "Raspberry Pi 3 GPIO Expander"
default RASPBERRYPI_FIRMWARE
depends on OF_GPIO
+ # Make sure not 'y' when RASPBERRYPI_FIRMWARE is 'm'. This can only
+ # happen when COMPILE_TEST=y, hence the added !RASPBERRYPI_FIRMWARE.
depends on (ARCH_BCM2835 && RASPBERRYPI_FIRMWARE) || (COMPILE_TEST && !RASPBERRYPI_FIRMWARE)
help
Turn on GPIO support for the expander on Raspberry Pi 3 boards, using
--
2.16.1
On Fri, Mar 2, 2018 at 10:47 AM, Baruch Siach <[email protected]> wrote:
> Commit 7ed915059c3001 (gpio: raspberrypi-ext: fix firmware dependency)
> fixed the Kconfig dependency to ensure that gpio-raspberrypi-exp is not
> built-in when the firmware is a module. But the Kconfig syntax for doing
> so is cryptic. Add a comment to make it a little easier.
>
> Cc: Arnd Bergmann <[email protected]>
> Signed-off-by: Baruch Siach <[email protected]>
Patch applied.
Yours,
Linus Walleij