On 06/26/2020 11:22 PM, Rakesh Pillai wrote:
> For debugging many issues, a history of the
> below mentioned events can help get an idea
> of what exactly was going on just before any
> issue occurred in the system. These event
> history will be collected only when the host
> driver is run in debug mode (i.e. with the
> config ATH10K_DEBUG enabled).
This should be disabled by default unless user specifically pokes some debugfs
value to turn it on so that it does not impact performance.
Thanks,
Ben
>
> Add history for tracking the below events
> - register read
> - register write
> - IRQ trigger
> - IRQ Enable
> - IRQ Disable
> - NAPI poll
> - CE service
> - WMI cmd
> - WMI event
> - WMI tx completion
>
> This will help in debugging any crash or any
> improper behaviour.
--
Ben Greear <[email protected]>
Candela Technologies Inc http://www.candelatech.com