This series is all the stragglers that didn't quite make the first
merge window pull. It's mostly minor updates and bug fixes of merge
window code but it also has two driver updates: ufs and qla2xxx.
James
The patch is available here:
git://git.kernel.org/pub/scm/linux/kernel/git/jejb/scsi.git scsi-misc
The short changelog is:
Adrian Hunter (1):
scsi: ufs: ufs-pci: Force a full restore after suspend-to-disk
Alexey Dobriyan (1):
scsi: sr: Remove duplicate assignment
Andrea Parri (Microsoft) (1):
scsi: storvsc: Fix validation for unsolicited incoming packets
Avri Altman (2):
scsi: ufs: ufshpb: Properly handle max-single-cmd
scsi: ufs: ufshpb: Remove HPB2.0 flows
Bart Van Assche (10):
scsi: ufs: core: Micro-optimize ufshcd_map_sg()
scsi: ufs: core: Add a compile-time structure size check
scsi: ufs: core: Remove three superfluous casts
scsi: ufs: core: Add debugfs attributes for triggering the UFS EH
scsi: ufs: core: Make it easier to add new debugfs attributes
scsi: ufs: core: Export ufshcd_schedule_eh_work()
scsi: ufs: core: Log error handler activity
scsi: ufs: core: Improve static type checking
scsi: ufs: core: Improve source code comments
scsi: ufs: Revert "Retry aborted SCSI commands instead of completing these successfully"
Brian King (1):
scsi: ibmvfc: Fix up duplicate response detection
Chanho Park (12):
scsi: ufs: ufs-exynos: Introduce ExynosAuto v9 virtual host
scsi: ufs: ufs-exynos: Multi-host configuration for ExynosAuto v9
scsi: ufs: ufs-exynos: Support ExynosAuto v9 UFS
scsi: ufs: ufs-exynos: Add pre/post_hce_enable drv callbacks
scsi: ufs: ufs-exynos: Factor out priv data init
scsi: ufs: ufs-exynos: Add EXYNOS_UFS_OPT_SKIP_CONFIG_PHY_ATTR option
scsi: ufs: ufs-exynos: Support custom version of ufs_hba_variant_ops
scsi: ufs: ufs-exynos: Add setup_clocks callback
scsi: ufs: ufs-exynos: Add refclkout_stop control
scsi: ufs: ufs-exynos: Simplify drv_data retrieval
scsi: ufs: ufs-exynos: Change pclk available max value
scsi: ufs: ufs-exynos: Correct timeout value setting registers
Christophe JAILLET (1):
scsi: elx: Use 'bitmap_zalloc()' when applicable
Dexuan Cui (1):
scsi: core: Fix shost->cmd_per_lun calculation in scsi_add_host_with_dma()
Dmitry Bogdanov (2):
scsi: target: core: Remove from tmr_list during LUN unlink
scsi: qla2xxx: Fix unmap of already freed sgl
Ewan D. Milne (1):
scsi: core: Avoid leaving shost->last_reset with stale value if EH does not run
George Kennedy (1):
scsi: scsi_debug: Don't call kcalloc() if size arg is zero
Jackie Liu (1):
scsi: bsg: Fix errno when scsi_bsg_register_queue() fails
Joy Gu (1):
scsi: qla2xxx: Fix a memory leak in an error path of qla2x00_process_els()
Martin K. Petersen (1):
scsi: mpt3sas: Fix reference tag handling for WRITE_INSERT
Mike Christie (1):
scsi: iscsi: Fix set_param() handling
Miles Chen (1):
scsi: sd: Fix crashes in sd_resume_runtime()
Ming Lei (1):
scsi: core: Put LLD module refcnt after SCSI device is released
Nilesh Javali (1):
scsi: qla2xxx: Update version to 10.02.07.200-k
Quinn Tran (12):
scsi: qla2xxx: edif: Fix EDIF bsg
scsi: qla2xxx: edif: Fix inconsistent check of db_flags
scsi: qla2xxx: edif: Increase ELS payload
scsi: qla2xxx: edif: Reduce connection thrash
scsi: qla2xxx: edif: Tweak trace message
scsi: qla2xxx: edif: Replace list_for_each_safe with list_for_each_entry_safe
scsi: qla2xxx: edif: Flush stale events and msgs on session down
scsi: qla2xxx: edif: Fix app start delay
scsi: qla2xxx: edif: Fix app start fail
scsi: qla2xxx: Turn off target reset during issue_lip
scsi: qla2xxx: Fix gnl list corruption
scsi: qla2xxx: Relogin during fabric disturbance
Sreekanth Reddy (1):
scsi: mpi3mr: Fix duplicate device entries when scanning through sysfs
Steffen Maier (1):
scsi: core: Fix early registration of sysfs attributes for scsi_device
Tadeusz Struk (2):
scsi: core: Remove command size deduction from scsi_setup_scsi_cmnd()
scsi: scsi_ioctl: Validate command size
Zheyu Ma (1):
scsi: qla2xxx: Return -ENOMEM if kzalloc() fails
jongmin jeong (2):
scsi: ufs: Add quirk to enable host controller without PH configuration
scsi: ufs: Add quirk to handle broken UIC command
On Fri, Nov 12, 2021 at 5:43 AM James Bottomley
<[email protected]> wrote:
>
> This series is all the stragglers that didn't quite make the first
> merge window pull. It's mostly minor updates and bug fixes of merge
> window code but it also has two driver updates: ufs and qla2xxx.
Hmm? No diffstat?
I suspect it's because there's a merge in there, and thus multiple
merge base commits, and the autogenerated diffstat ends up being
worthless.
In that situation, the nice thing to do is to at least tell me why
there's no diffstat, but optimally you can do a temporary throw-away
merge in a temporary branch just to get the diffstat.
And yes, "git request-pull" could do that, automating this all and
reporting any conflicts at the same time.
But git historically did *not* do that just because it requires a
working tree and can be messy, and because the "just do the diff from
the merge base" works fine for maintainers that don't do merges
themselves, and so the only maintainers that can hit this issue are
the maintainers that also should be able to do that temporary merge
thing on their own.
Anyway, I don't require that temporary merge, but I _do_ really want
to get notified of "look, I did the diffstat, and it was useless
garbage, so I'm not including it here".
Because as-is, this just looks like an incomplete pull request.
I've done the pull, verified the shortlog, and checked that the
(proper) diffstat all looks sane. But I am writing this email just to
say "you could have done so much better".
Linus
The pull request you sent on Fri, 12 Nov 2021 08:43:14 -0500:
> git://git.kernel.org/pub/scm/linux/kernel/git/jejb/scsi.git scsi-misc
has been merged into torvalds/linux.git:
https://git.kernel.org/torvalds/c/6cbcc7ab2147d721700029a78558dc0ea4207153
Thank you!
--
Deet-doot-dot, I am a bot.
https://korg.docs.kernel.org/prtracker.html
On Fri, 2021-11-12 at 12:34 -0800, Linus Torvalds wrote:
> On Fri, Nov 12, 2021 at 5:43 AM James Bottomley
> <[email protected]> wrote:
> > This series is all the stragglers that didn't quite make the first
> > merge window pull. It's mostly minor updates and bug fixes of
> > merge window code but it also has two driver updates: ufs and
> > qla2xxx.
>
> Hmm? No diffstat?
>
> I suspect it's because there's a merge in there, and thus multiple
> merge base commits, and the autogenerated diffstat ends up being
> worthless.
Um, no, it's because I forgot, sorry.
> In that situation, the nice thing to do is to at least tell me why
> there's no diffstat, but optimally you can do a temporary throw-away
> merge in a temporary branch just to get the diffstat.
>
> And yes, "git request-pull" could do that, automating this all and
> reporting any conflicts at the same time.
>
> But git historically did *not* do that just because it requires a
> working tree and can be messy, and because the "just do the diff from
> the merge base" works fine for maintainers that don't do merges
> themselves, and so the only maintainers that can hit this issue are
> the maintainers that also should be able to do that temporary merge
> thing on their own.
>
> Anyway, I don't require that temporary merge, but I _do_ really want
> to get notified of "look, I did the diffstat, and it was useless
> garbage, so I'm not including it here".
>
> Because as-is, this just looks like an incomplete pull request.
>
> I've done the pull, verified the shortlog, and checked that the
> (proper) diffstat all looks sane. But I am writing this email just to
> say "you could have done so much better".
Will do next time, sorry.
James