The patchset contains two independent updates to tegra-i2c driver.
* Update I2C DMA channel usage to use single DMA channel instead of
two different hardware channels.
* Fix PEC byte issue during SMBus block read caused by mismanaged
msg->len property in i2c_msg struct.
v3->v4:
Combine the two patches to one series to avoid merge conflicts.
Adding the latest independent version links below.
https://lkml.kernel.org/lkml/ZBxZlNOhLyUZi1B+@orome/T/#mb41b90701e70d9663d54455c7e014a528c589284
https://lkml.kernel.org/lkml/[email protected]/T/#u
Akhil R (2):
i2c: tegra: Fix PEC support for SMBUS block read
i2c: tegra: Share same DMA channel for RX and TX
drivers/i2c/busses/i2c-tegra.c | 107 ++++++++++++++-------------------
1 file changed, 46 insertions(+), 61 deletions(-)
--
2.17.1
Allocate only one DMA channel for I2C and share it for both TX and RX
instead of using two different DMA hardware channels with the same
slave ID. Since I2C supports only half duplex, there is no impact on
perf with this.
Signed-off-by: Akhil R <[email protected]>
---
drivers/i2c/busses/i2c-tegra.c | 69 ++++++++++------------------------
1 file changed, 20 insertions(+), 49 deletions(-)
diff --git a/drivers/i2c/busses/i2c-tegra.c b/drivers/i2c/busses/i2c-tegra.c
index 83e74b8baf67..b15829ff2aab 100644
--- a/drivers/i2c/busses/i2c-tegra.c
+++ b/drivers/i2c/busses/i2c-tegra.c
@@ -249,8 +249,7 @@ struct tegra_i2c_hw_feature {
* @msg_read: indicates that the transfer is a read access
* @timings: i2c timings information like bus frequency
* @multimaster_mode: indicates that I2C controller is in multi-master mode
- * @tx_dma_chan: DMA transmit channel
- * @rx_dma_chan: DMA receive channel
+ * @dma_chan: DMA channel
* @dma_phys: handle to DMA resources
* @dma_buf: pointer to allocated DMA buffer
* @dma_buf_size: DMA buffer size
@@ -283,8 +282,7 @@ struct tegra_i2c_dev {
__u16 msg_len;
struct completion dma_complete;
- struct dma_chan *tx_dma_chan;
- struct dma_chan *rx_dma_chan;
+ struct dma_chan *dma_chan;
unsigned int dma_buf_size;
struct device *dma_dev;
dma_addr_t dma_phys;
@@ -393,16 +391,14 @@ static int tegra_i2c_dma_submit(struct tegra_i2c_dev *i2c_dev, size_t len)
{
struct dma_async_tx_descriptor *dma_desc;
enum dma_transfer_direction dir;
- struct dma_chan *chan;
dev_dbg(i2c_dev->dev, "starting DMA for length: %zu\n", len);
reinit_completion(&i2c_dev->dma_complete);
dir = i2c_dev->msg_read ? DMA_DEV_TO_MEM : DMA_MEM_TO_DEV;
- chan = i2c_dev->msg_read ? i2c_dev->rx_dma_chan : i2c_dev->tx_dma_chan;
- dma_desc = dmaengine_prep_slave_single(chan, i2c_dev->dma_phys,
+ dma_desc = dmaengine_prep_slave_single(i2c_dev->dma_chan, i2c_dev->dma_phys,
len, dir, DMA_PREP_INTERRUPT |
DMA_CTRL_ACK);
if (!dma_desc) {
@@ -415,7 +411,7 @@ static int tegra_i2c_dma_submit(struct tegra_i2c_dev *i2c_dev, size_t len)
dma_desc->callback_param = i2c_dev;
dmaengine_submit(dma_desc);
- dma_async_issue_pending(chan);
+ dma_async_issue_pending(i2c_dev->dma_chan);
return 0;
}
@@ -428,20 +424,14 @@ static void tegra_i2c_release_dma(struct tegra_i2c_dev *i2c_dev)
i2c_dev->dma_buf = NULL;
}
- if (i2c_dev->tx_dma_chan) {
- dma_release_channel(i2c_dev->tx_dma_chan);
- i2c_dev->tx_dma_chan = NULL;
- }
-
- if (i2c_dev->rx_dma_chan) {
- dma_release_channel(i2c_dev->rx_dma_chan);
- i2c_dev->rx_dma_chan = NULL;
+ if (i2c_dev->dma_chan) {
+ dma_release_channel(i2c_dev->dma_chan);
+ i2c_dev->dma_chan = NULL;
}
}
static int tegra_i2c_init_dma(struct tegra_i2c_dev *i2c_dev)
{
- struct dma_chan *chan;
dma_addr_t dma_phys;
u32 *dma_buf;
int err;
@@ -459,25 +449,18 @@ static int tegra_i2c_init_dma(struct tegra_i2c_dev *i2c_dev)
return 0;
}
- chan = dma_request_chan(i2c_dev->dev, "rx");
- if (IS_ERR(chan)) {
- err = PTR_ERR(chan);
- goto err_out;
- }
-
- i2c_dev->rx_dma_chan = chan;
-
- chan = dma_request_chan(i2c_dev->dev, "tx");
- if (IS_ERR(chan)) {
- err = PTR_ERR(chan);
+ /*
+ * The same channel will be used for both RX and TX.
+ * Keeping the name as "tx" for backward compatibility
+ * with existing devicetrees.
+ */
+ i2c_dev->dma_chan = dma_request_chan(i2c_dev->dev, "tx");
+ if (IS_ERR(i2c_dev->dma_chan)) {
+ err = PTR_ERR(i2c_dev->dma_chan);
goto err_out;
}
- i2c_dev->tx_dma_chan = chan;
-
- WARN_ON(i2c_dev->tx_dma_chan->device != i2c_dev->rx_dma_chan->device);
- i2c_dev->dma_dev = chan->device->dev;
-
+ i2c_dev->dma_dev = i2c_dev->dma_chan->device->dev;
i2c_dev->dma_buf_size = i2c_dev->hw->quirks->max_write_len +
I2C_PACKET_HEADER_SIZE;
@@ -976,11 +959,7 @@ static irqreturn_t tegra_i2c_isr(int irq, void *dev_id)
dvc_writel(i2c_dev, DVC_STATUS_I2C_DONE_INTR, DVC_STATUS);
if (i2c_dev->dma_mode) {
- if (i2c_dev->msg_read)
- dmaengine_terminate_async(i2c_dev->rx_dma_chan);
- else
- dmaengine_terminate_async(i2c_dev->tx_dma_chan);
-
+ dmaengine_terminate_async(i2c_dev->dma_chan);
complete(&i2c_dev->dma_complete);
}
@@ -994,7 +973,6 @@ static void tegra_i2c_config_fifo_trig(struct tegra_i2c_dev *i2c_dev,
{
struct dma_slave_config slv_config = {0};
u32 val, reg, dma_burst, reg_offset;
- struct dma_chan *chan;
int err;
if (i2c_dev->hw->has_mst_fifo)
@@ -1011,7 +989,6 @@ static void tegra_i2c_config_fifo_trig(struct tegra_i2c_dev *i2c_dev,
dma_burst = 8;
if (i2c_dev->msg_read) {
- chan = i2c_dev->rx_dma_chan;
reg_offset = tegra_i2c_reg_addr(i2c_dev, I2C_RX_FIFO);
slv_config.src_addr = i2c_dev->base_phys + reg_offset;
@@ -1023,7 +1000,6 @@ static void tegra_i2c_config_fifo_trig(struct tegra_i2c_dev *i2c_dev,
else
val = I2C_FIFO_CONTROL_RX_TRIG(dma_burst);
} else {
- chan = i2c_dev->tx_dma_chan;
reg_offset = tegra_i2c_reg_addr(i2c_dev, I2C_TX_FIFO);
slv_config.dst_addr = i2c_dev->base_phys + reg_offset;
@@ -1037,7 +1013,7 @@ static void tegra_i2c_config_fifo_trig(struct tegra_i2c_dev *i2c_dev,
}
slv_config.device_fc = true;
- err = dmaengine_slave_config(chan, &slv_config);
+ err = dmaengine_slave_config(i2c_dev->dma_chan, &slv_config);
if (err) {
dev_err(i2c_dev->dev, "DMA config failed: %d\n", err);
dev_err(i2c_dev->dev, "falling back to PIO\n");
@@ -1347,13 +1323,8 @@ static int tegra_i2c_xfer_msg(struct tegra_i2c_dev *i2c_dev,
* performs synchronization after the transfer's termination
* and we want to get a completion if transfer succeeded.
*/
- dmaengine_synchronize(i2c_dev->msg_read ?
- i2c_dev->rx_dma_chan :
- i2c_dev->tx_dma_chan);
-
- dmaengine_terminate_sync(i2c_dev->msg_read ?
- i2c_dev->rx_dma_chan :
- i2c_dev->tx_dma_chan);
+ dmaengine_synchronize(i2c_dev->dma_chan);
+ dmaengine_terminate_sync(i2c_dev->dma_chan);
if (!time_left && !completion_done(&i2c_dev->dma_complete)) {
dev_err(i2c_dev->dev, "DMA transfer timed out\n");
--
2.17.1
On Fri, Mar 24, 2023 at 05:29:24PM +0530, Akhil R wrote:
> Allocate only one DMA channel for I2C and share it for both TX and RX
> instead of using two different DMA hardware channels with the same
> slave ID. Since I2C supports only half duplex, there is no impact on
> perf with this.
>
> Signed-off-by: Akhil R <[email protected]>
> ---
> drivers/i2c/busses/i2c-tegra.c | 69 ++++++++++------------------------
> 1 file changed, 20 insertions(+), 49 deletions(-)
Looks good:
Acked-by: Thierry Reding <[email protected]>