Hi Doug
Thank you for mentioning this patch.
I think the focus of the discussion is: can we put the grf control bit
to dts.
The RK3399 has 2 Type-C phy, but only one DP controller, this "uphy_dp_sel"
can help to switch these 2 phy. So I think this bit can be considered as
a part of
Type-C phy, these 2 phy have different bits, just similar to other bits
(such as "pipe-status").
Put them to DTS file might be a accepted practice.
On 2017年11月29日 07:32, Doug Anderson wrote:
> Hi,
>
> On Thu, Feb 9, 2017 at 11:44 PM, Chris Zhong <[email protected]> wrote:
>> There are 2 Type-c PHYs in RK3399, but only one DP controller. Hence
>> only one PHY can connect to DP controller at one time, the other should
>> be disconnected. The GRF_SOC_CON26 register has a switch bit to do it,
>> set this bit means enable PHY 1, clear this bit means enable PHY 0.
>>
>> If the board has 2 Type-C ports, the DP driver get the phy id from
>> devm_of_phy_get_by_index, and then control this switch according to
>> this id. But some others board only has one Type-C port, it may be PHY 0
>> or PHY 1. The dts node id can not tell us the correct PHY id. Hence move
>> this switch to PHY driver, the PHY driver can distinguish between PHY 0
>> and PHY 1, and then write the correct register bit.
>>
>>
>>
>> Chris Zhong (4):
>> Documentation: bindings: add uphy-dp-sel for Rockchip USB Type-C PHY
>> arm64: dts: rockchip: add rockchip,uphy-dp-sel for Type-C phy
>> phy: rockchip-typec: support DP phy switch
>> drm/rockchip: cdn-dp: remove the DP phy switch
>>
>> Documentation/devicetree/bindings/phy/phy-rockchip-typec.txt | 5 +++++
>> arch/arm64/boot/dts/rockchip/rk3399.dtsi | 2 ++
>> drivers/gpu/drm/rockchip/cdn-dp-core.c | 7 -------
>> drivers/phy/phy-rockchip-typec.c | 9 +++++++++
>> 4 files changed, 16 insertions(+), 7 deletions(-)
> What ever happened to this series? It seemed like it just dropped on
> the floor...
>
> There was a bit of contention on patch #3
> <https://patchwork.kernel.org/patch/9566095/> about the fact that we
> were specifying addresses in the device tree vs. hardcoding them in
> the driver. Any way we can just make a decision and go with it?
>
>
> -Doug
>
>
>
--
Chris Zhong
From 1585354663471655077@xxx Tue Nov 28 23:33:44 +0000 2017
X-GM-THRID: 1585354663471655077
X-Gmail-Labels: Inbox,Category Forums,HistoricalUnread