Hello Martin
> David Stockwell wrote:
>> While attempting to test SSP with 3.34-3.35, I found that I was
>> unable
>> to pair with SSP; I was able to pair with the legacy
>> pin-request/response mode. I checked the HCI level of my aging BT
>> dongle (somehow this sounds a bit "dirty"), and found that it was
>> only
>> HCI 1.1 compliant. Replacing it with a BT2.0+EDR compliant dongle, I
>> found that it still would not pair with SSP.
>>
>> Consulting with CSR, they confirmed that unless both devices are
>> Bluetooth HCI 2.1 compliant, SSP will not work; it will always fall
>> back
>> to Legacy pairing.
>>
>> I searched yesterday for HCI 2.1-compliant dongles, and found only
>> one,
>> from Logitec (not Logitech) in Japan. These are not available in the
>> US
>> market.
>>
>
> you can update CSRs BT2.0 with 2.1 Firmware. That should work. I think
> you can download the firmware on the csr support site.
>
I will give this a shot. Thanks. Will also need to see if my even
newer dongle can be upgraded.
DS
>
>
-------------------------------------------------------------------------
Sponsored by: SourceForge.net Community Choice Awards: VOTE NOW!
Studies have shown that voting for your favorite open source project,
along with a healthy diet, reduces your potential for chronic lameness
and boredom. Vote Now at http://www.sourceforge.net/community/cca08
_______________________________________________
Bluez-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/bluez-devel