This patch moves the sanity check on beacon interval
which was done only for mesh mode to all operating
modes just to be safe.
Signed-off-by: Vasanthakumar Thiagarajan <[email protected]>
---
drivers/net/wireless/ath/ath9k/beacon.c | 15 ++++++++-------
1 files changed, 8 insertions(+), 7 deletions(-)
diff --git a/drivers/net/wireless/ath/ath9k/beacon.c b/drivers/net/wireless/ath/ath9k/beacon.c
index 3639a2e..45c4ea5 100644
--- a/drivers/net/wireless/ath/ath9k/beacon.c
+++ b/drivers/net/wireless/ath/ath9k/beacon.c
@@ -674,13 +674,6 @@ static void ath_beacon_config_adhoc(struct ath_softc *sc,
intval = conf->beacon_interval & ATH9K_BEACON_PERIOD;
- /*
- * It looks like mac80211 may end up using beacon interval of zero in
- * some cases (at least for mesh point). Avoid getting into an
- * infinite loop by using a bit safer value instead..
- */
- if (intval == 0)
- intval = 100;
/* Pull nexttbtt forward to reflect the current TSF */
@@ -745,6 +738,14 @@ void ath_beacon_config(struct ath_softc *sc, struct ieee80211_vif *vif)
iftype = sc->sc_ah->opmode;
}
+ /*
+ * It looks like mac80211 may end up using beacon interval of zero in
+ * some cases (at least for mesh point). Avoid getting into an
+ * infinite loop by using a bit safer value instead. To be safe,
+ * do sanity check on beacon interval for all operating modes.
+ */
+ if (cur_conf->beacon_interval == 0)
+ cur_conf->beacon_interval = 100;
switch (iftype) {
case NL80211_IFTYPE_AP:
--
1.5.5.1