Remove the CONT_* and LNA_* messages from
AR_MCI_INTERRUPT_RX_MSG_DEFAULT. Those MCI rx messages only
meant for debugging purpose. Including them in default rx_msg
series could raise huge amount of MCI interrupts when BT traffic
is going on. And also it increases power consumption when WLAN
is scanning.
Signed-off-by: Rajkumar Manoharan <[email protected]>
---
drivers/net/wireless/ath/ath9k/reg.h | 6 ------
1 file changed, 6 deletions(-)
diff --git a/drivers/net/wireless/ath/ath9k/reg.h b/drivers/net/wireless/ath/ath9k/reg.h
index 22d2413..6592c07 100644
--- a/drivers/net/wireless/ath/ath9k/reg.h
+++ b/drivers/net/wireless/ath/ath9k/reg.h
@@ -2081,12 +2081,6 @@ enum {
AR_MCI_INTERRUPT_RX_MSG_REMOTE_RESET| \
AR_MCI_INTERRUPT_RX_MSG_SYS_WAKING | \
AR_MCI_INTERRUPT_RX_MSG_SYS_SLEEPING| \
- AR_MCI_INTERRUPT_RX_MSG_SCHD_INFO | \
- AR_MCI_INTERRUPT_RX_MSG_LNA_CONTROL | \
- AR_MCI_INTERRUPT_RX_MSG_LNA_INFO | \
- AR_MCI_INTERRUPT_RX_MSG_CONT_NACK | \
- AR_MCI_INTERRUPT_RX_MSG_CONT_INFO | \
- AR_MCI_INTERRUPT_RX_MSG_CONT_RST | \
AR_MCI_INTERRUPT_RX_MSG_REQ_WAKE)
#define AR_MCI_CPU_INT 0x1840
--
1.7.11.1