2016-10-10 18:40:32

by Aaron Brice

[permalink] [raw]
Subject: [PATCH v2] sdhci-esdhc-imx: Correct two register accesses

- The DMA error interrupt bit is in a different position as
compared to the sdhci standard. This is accounted for in
many cases, but not handled in the case of clearing the
INT_STATUS register by writing a 1 to that location.
- The HOST_CONTROL register is very different as compared to
the sdhci standard. This is accounted for in the write
case, but not when read back out (which it is in the sdhci
code).

Signed-off-by: Dave Russell <[email protected]>
Signed-off-by: Aaron Brice <[email protected]>
Acked-by: Dong Aisheng <[email protected]>
---
v1 -> v2:
- rename long_val to val

drivers/mmc/host/sdhci-esdhc-imx.c | 23 ++++++++++++++++++++++-
1 file changed, 22 insertions(+), 1 deletion(-)

diff --git a/drivers/mmc/host/sdhci-esdhc-imx.c b/drivers/mmc/host/sdhci-esdhc-imx.c
index 1f54fd8..7123ef9 100644
--- a/drivers/mmc/host/sdhci-esdhc-imx.c
+++ b/drivers/mmc/host/sdhci-esdhc-imx.c
@@ -346,7 +346,8 @@ static void esdhc_writel_le(struct sdhci_host *host, u32 val, int reg)
struct pltfm_imx_data *imx_data = sdhci_pltfm_priv(pltfm_host);
u32 data;

- if (unlikely(reg == SDHCI_INT_ENABLE || reg == SDHCI_SIGNAL_ENABLE)) {
+ if (unlikely(reg == SDHCI_INT_ENABLE || reg == SDHCI_SIGNAL_ENABLE ||
+ reg == SDHCI_INT_STATUS)) {
if ((val & SDHCI_INT_CARD_INT) && !esdhc_is_usdhc(imx_data)) {
/*
* Clear and then set D3CD bit to avoid missing the
@@ -555,6 +556,25 @@ static void esdhc_writew_le(struct sdhci_host *host, u16 val, int reg)
esdhc_clrset_le(host, 0xffff, val, reg);
}

+static u8 esdhc_readb_le(struct sdhci_host *host, int reg)
+{
+ u8 ret;
+ u32 val;
+
+ switch (reg) {
+ case SDHCI_HOST_CONTROL:
+ val = readl(host->ioaddr + reg);
+
+ ret = val & SDHCI_CTRL_LED;
+ ret |= (val >> 5) & SDHCI_CTRL_DMA_MASK;
+ ret |= (val & ESDHC_CTRL_4BITBUS);
+ ret |= (val & ESDHC_CTRL_8BITBUS) << 3;
+ return ret;
+ }
+
+ return readb(host->ioaddr + reg);
+}
+
static void esdhc_writeb_le(struct sdhci_host *host, u8 val, int reg)
{
struct sdhci_pltfm_host *pltfm_host = sdhci_priv(host);
@@ -947,6 +967,7 @@ static void esdhc_set_timeout(struct sdhci_host *host, struct mmc_command *cmd)
static struct sdhci_ops sdhci_esdhc_ops = {
.read_l = esdhc_readl_le,
.read_w = esdhc_readw_le,
+ .read_b = esdhc_readb_le,
.write_l = esdhc_writel_le,
.write_w = esdhc_writew_le,
.write_b = esdhc_writeb_le,
--
2.7.4


2016-10-11 09:25:17

by Adrian Hunter

[permalink] [raw]
Subject: Re: [PATCH v2] sdhci-esdhc-imx: Correct two register accesses

On 10/10/16 21:39, Aaron Brice wrote:
> - The DMA error interrupt bit is in a different position as
> compared to the sdhci standard. This is accounted for in
> many cases, but not handled in the case of clearing the
> INT_STATUS register by writing a 1 to that location.
> - The HOST_CONTROL register is very different as compared to
> the sdhci standard. This is accounted for in the write
> case, but not when read back out (which it is in the sdhci
> code).
>
> Signed-off-by: Dave Russell <[email protected]>
> Signed-off-by: Aaron Brice <[email protected]>
> Acked-by: Dong Aisheng <[email protected]>

Acked-by: Adrian Hunter <[email protected]>


2016-10-13 07:02:15

by Ulf Hansson

[permalink] [raw]
Subject: Re: [PATCH v2] sdhci-esdhc-imx: Correct two register accesses

On 10 October 2016 at 20:39, Aaron Brice <[email protected]> wrote:
>
> - The DMA error interrupt bit is in a different position as
> compared to the sdhci standard. This is accounted for in
> many cases, but not handled in the case of clearing the
> INT_STATUS register by writing a 1 to that location.
> - The HOST_CONTROL register is very different as compared to
> the sdhci standard. This is accounted for in the write
> case, but not when read back out (which it is in the sdhci
> code).
>
> Signed-off-by: Dave Russell <[email protected]>
> Signed-off-by: Aaron Brice <[email protected]>
> Acked-by: Dong Aisheng <[email protected]>
> ---

Thanks, applied for fixes!

Kind regards
Uffe

>
> v1 -> v2:
> - rename long_val to val
>
> drivers/mmc/host/sdhci-esdhc-imx.c | 23 ++++++++++++++++++++++-
> 1 file changed, 22 insertions(+), 1 deletion(-)
>
> diff --git a/drivers/mmc/host/sdhci-esdhc-imx.c b/drivers/mmc/host/sdhci-esdhc-imx.c
> index 1f54fd8..7123ef9 100644
> --- a/drivers/mmc/host/sdhci-esdhc-imx.c
> +++ b/drivers/mmc/host/sdhci-esdhc-imx.c
> @@ -346,7 +346,8 @@ static void esdhc_writel_le(struct sdhci_host *host, u32 val, int reg)
> struct pltfm_imx_data *imx_data = sdhci_pltfm_priv(pltfm_host);
> u32 data;
>
> - if (unlikely(reg == SDHCI_INT_ENABLE || reg == SDHCI_SIGNAL_ENABLE)) {
> + if (unlikely(reg == SDHCI_INT_ENABLE || reg == SDHCI_SIGNAL_ENABLE ||
> + reg == SDHCI_INT_STATUS)) {
> if ((val & SDHCI_INT_CARD_INT) && !esdhc_is_usdhc(imx_data)) {
> /*
> * Clear and then set D3CD bit to avoid missing the
> @@ -555,6 +556,25 @@ static void esdhc_writew_le(struct sdhci_host *host, u16 val, int reg)
> esdhc_clrset_le(host, 0xffff, val, reg);
> }
>
> +static u8 esdhc_readb_le(struct sdhci_host *host, int reg)
> +{
> + u8 ret;
> + u32 val;
> +
> + switch (reg) {
> + case SDHCI_HOST_CONTROL:
> + val = readl(host->ioaddr + reg);
> +
> + ret = val & SDHCI_CTRL_LED;
> + ret |= (val >> 5) & SDHCI_CTRL_DMA_MASK;
> + ret |= (val & ESDHC_CTRL_4BITBUS);
> + ret |= (val & ESDHC_CTRL_8BITBUS) << 3;
> + return ret;
> + }
> +
> + return readb(host->ioaddr + reg);
> +}
> +
> static void esdhc_writeb_le(struct sdhci_host *host, u8 val, int reg)
> {
> struct sdhci_pltfm_host *pltfm_host = sdhci_priv(host);
> @@ -947,6 +967,7 @@ static void esdhc_set_timeout(struct sdhci_host *host, struct mmc_command *cmd)
> static struct sdhci_ops sdhci_esdhc_ops = {
> .read_l = esdhc_readl_le,
> .read_w = esdhc_readw_le,
> + .read_b = esdhc_readb_le,
> .write_l = esdhc_writel_le,
> .write_w = esdhc_writew_le,
> .write_b = esdhc_writeb_le,
> --
> 2.7.4
>